8-/4-Channel, 짹VREF Multirange Inputs, Serial 14-Bit ADCs

General Description The MAX1034/MAX1035 multirange, low-power, 14-bit, successive-approximation, analog-to-digital converters (ADCs) operate from a single +5V supply and achieve throughput rates up to 115ksps. A separate digital supply allows digital interfacing with 2.7V to 5.25V systems using t

8/4通道、±VREF多量程输入、串行14位ADC

MAX1034/MAX1035是多量程、低功耗、14位逐次逼近型模数转换器(ADC)，采用+5V单电源供电，转换速率高达115ksps。独立的数字电源允许通过SPI™/QSPI™/MICROWIRE™兼容的串行接口与2.7V至5.25V系统连接。局部关断模式可将电源电流降至1.3mA (典型值)。完全关断模式则可将电源电流降至1µA (典型值)。\n\n MAX1034提供8路(单端)或4路(真差分)模拟输入通道。MAX1035则具有4路(单端)或2路(真差分)模拟输入通道。每个模拟输入通道都可通过软件独立编程设置为7种单端输入范围(0至+VREF/2、-VREF/2至0、0至+VR • 每个通道的输入范围可通过软件编程设置\n• 单端输入范围\n• 0至+VREF/2、-VREF/2至0、0至+VREF、-VREF至0、±VREF/4、±VREF/2和±VREF\n\n\n• 差分输入范围\n• ±VREF / 2、±VREF和±2 x VREF\n\n\n• 8路单端或4路差分模拟输入(MAX1034)\n• 4路单端或2路差分模拟输入(MAX1035)\n• ±6V过压容限输入\n• 内部或外部基准\n• 115ksps最高采样速率\n• +5V单电源供电\n• 20/24引脚TSSOP封装;

8-/4-Channel, ±VREF Multirange Inputs, Serial 14-Bit ADCs

文件：431.54 Kbytes Page：31 Pages

8-/4-Channel, 짹VREF Multirange Inputs, Serial 14-Bit ADCs

General Description The MAX1034/MAX1035 multirange, low-power, 14-bit, successive-approximation, analog-to-digital converters (ADCs) operate from a single +5V supply and achieve throughput rates up to 115ksps. A separate digital supply allows digital interfacing with 2.7V to 5.25V systems using t

8-/4-Channel, ±VREF Multirange Inputs, Serial 14-Bit ADCs

文件：431.54 Kbytes Page：31 Pages

封装/外壳：20-TSSOP（0.173"，4.40mm 宽） 包装：托盘 描述：IC ADC 14BIT SAR 20TSSOP 集成电路（IC） 模数转换器（ADC）

SCHOTTKY BARRIER RECTIFIERS 10 AMPERES 20 to 45 VOLTS

Switchmode Power Rectifiers . . . using the Schottky Barrier principle with a platinum barrier metal. These state–of–the–art devices have the following features: • Guardring for Stress Protection • Low Forward Voltage • 150°C Operating Junction Temperature • Guaranteed Reverse Avalanche • Ep

SWITCHMODE??Schottky Rectifier D2PAK Power Surface Mount Package

SWITCHMODE Schottky Power Rectifier DPAK Power Surface Mount Package . . . employing the Schottky Barrier principle in a large area metal–to–silicon power diode. State of the art geometry features epitaxial construction with oxide passivation and metal overlay contact. Ideally suited for low vol

MICROWAVE POWER TRANSISTOR

The RF Line Microwave Pulse Power Transistor Designed for 1025–1150 MHz pulse common base amplifier applications such as TCAS, TACAN and Mode–S transmitters. • Guaranteed Performance @ 1090 MHz Output Power = 350 Watts Peak Gain = 8.5 dB Min, 9.0 dB (Typ) • 100 Tested for Load Mismatch

MICROWAVE POWER TRANSISTORS

The RF Line Microwave Pulse Power Transistor Designed for Class B and C common base amplifier applications in short and long pulse TACAN, IFF, DME, and radar transmitters. • Guaranteed Performance @ 1090 MHz, 50 Vdc Output Power = 35 Watts Peak Minimum Gain = 10 dB • 100 Tested for Loa

SCHOTTKY BARRIER RECTIFIERS(10A,30-45V)

SWITCHMODE POWER RECTIFIERS D PAK SURFACE MOUNT POWER PACKAGE The D PAK Power rectifier employs the Schottky Barrier principle with a Molybdenum barrier metal. These state-of-the-art devices have the following features: * Low Forward Voltage * Low Switching noise * High Surge Capacity * Guara