防风、防鸟啄、防雨户外监测专用麦克风

SS 603是户外监测专用的麦克风套件，防风噪，防雨，还可防止鸟类栖息等影响，适合在户外常规天气下使用。防鸟锥可以轻松拆卸，方便日常维护校准。外壳采用铝合金材质并经过表面处理，耐环境腐蚀，保证传声器的长期稳定性。\n\nSS 603 满足IP55 防护等级，80mm 直径防风罩及内部防雨罩，防尘网，可对传声器进行充分保护，能经受风雨雪等恶劣天气的考验，并防止沙尘对传声器的破坏。\n\n它内部使用1/2 英寸预极化自由场测量传声器和前置放大器，采用BNC 接口。搭配 MegaSig PM 0083 等IEPE 信号调理器达到最佳测试效果。 符合IEC 61094-4 对于WS2F 型测量传声器要求\n\n满足IP55 防护等级，对风、雨、雪、沙尘等进行防护\n\n防风噪，防鸟类栖息\n\n保护套件可快速拆卸，方便定期进行声校准\n\n低本底噪声，典型本底噪声为17dBA\n\nIEPE 供电;

Shielded SMD Power Inductor

SMD shielded power inductor use outside ferrite ring to collect magnetic flux. It can reduce magnetic path through go outside of inductor to influence other component or circuit. It is good for high density PCB assembly.

Shielded SMD Power Inductor

SMD shielded power inductor use outside ferrite ring to collect magnetic flux. It can reduce magnetic path through go outside of inductor to influence other component or circuit. It is good for high density PCB assembly.

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

SHIELDED SMD POWER INDUCTOR

文件：136.34 Kbytes Page：8 Pages

PHASE CONTROL THYRISTOR

PHASE CONTROL THYRISTOR Repetitive voltage up to 1600 V Mean on-state current 720 A Surge current 8.8 kA

DPAK SURFACE MOUNT SUPER FAST RECOVERY RECTIFIER(VOLTAGE - 200 to 600 Volts CURRENT - 6.0 Amperes)

VOLTAGE 200 to 600 Volts CURRENT 6.0 Amperes FEATURES • Superfast recovery times-epitaxial construction. • Low forward voltage, high current capability. • Exceeds environmental standards of MIL-S-19500/228. • Hermetically sealed. • Low leakage. • High surge capability. • Plastic package ha

SUPER FAST RECOVERY RECTIFIER(VOLTAGE - 200 to 600 Volts CURRENT - 6.0 Amperes)

SUPER FAST RECOVERY RECTIFIER VOLTAGE - 200 to 600 Volts CURRENT - 6.0 Amperes FEATURES • For thorough hole applications • Low profile package • Built-in strain relief • Easy pick and place • Superfast recovery times for high efficiency • Plastic package has Underwriters

TrenchMOS/ Schottky diode array Three phase brushless d.c. motor driver

GENERAL DESCRIPTION Six n-channel, enhancement mode, logic level, field-effect power transistors and six schottky diodes configured as three half-bridges. This device has low on-state resistance and fast switching. The intended application is in computer disk and tape drives as a three phase brus

P-CHANNEL MOS FET 6-PIN 2 CIRCUITS

P-CHANNEL MOS FET (6-PIN 2 CIRCUITS) The µPA603T is a mini-mold device provided with two MOS FET circuits. It achieves high-density mounting and saves mounting costs. FEATURES • Two MOS FET circuits in package the same size as SC-59 • Complement to µPA602T • Automatic mounting