The SG3525A PWM Controller offers improved performance and_lower external parts count_when implemented for controlling all types of switching power supplies. The on-chip +5.1 V reference is trimmed to +/-1%_and_the error amplifier has an input common-mode voltage range that includes the reference voltage， thus eliminating the need for external divider resistors. A sync input to the oscillator enables multiple units to be slaved or a single unit to be synchronized to an external system clock. A wide range of deadtime can be programmed by a single resistor connected between the CT and_Discharge pins. This device also features built-in soft-start circuitry， requiring only an external timing capacitor. A shutdown pin controls both the soft-start circuitry and_the output stages， providing instantaneous turn off through the PWM latch with pulsed shutdown， as well as soft-start recycle with longer shutdown commands. The under voltage lockout inhibits the outputs and_the changing of the soft-start capacitor when VCC is below nominal. The output stages are totem-pole design capable of sinking and_sourcing in excess of 200 mA. The output stage of the SG3525A features NOR logic resulting in a low output for an off-state.
特性
8.0 V to 35 V Operation
5.1 V +/- 1.0%_Trimmed Reference
100 Hz to 400 kHz Oscillator Range
Separate Oscillator Sync Pin
Adjustable Deadtime Control
Input Undervoltage Lockout
Latching PWM to Prevent Multiple Pulses
Pulse-by-Pulse Shutdown
Dual Source/Sink Outputs: +/- 400 mA Peak
Pb-Free Packages are Available*_
应用
Half Bridge
Push-Pull
