Dual Path RF Switch / LNA DVGA - 3.3GHz to 4.0GHz

The F0453C is an integrated dual-path RF front-end consisting of an RF switch and two gain stages with 6dB gain control used in the analog front-end receiver of an Active Antenna System (AAS).\n\nThe F0453C provides 35dB gain with +23dBm OIP3, +15dBm output P1dB, and 1.35dB noise figure at 3500MHz. Gain at 3500MHz35dB typical in High Gain Mode\n29dB typical in Low Gain Mode;

Dual Path RF Switch with LNA and DVGA 3300MHz to 4000MHz

文件：1.798 Mbytes Page：30 Pages

Dual Path RF Switch with LNA and DVGA 3300MHz to 4000MHz

文件：1.798 Mbytes Page：30 Pages

Dual Path RF Switch with LNA and DVGA 3300MHz to 4000MHz

文件：1.798 Mbytes Page：30 Pages

封装/外壳：32-WFLGA 裸露焊盘 包装：卷带（TR） 描述：LGA 6.00X6.00X0.80 MM, 0.50MM PI RF/IF，射频/中频和 RFID 射频放大器

封装/外壳：32-WFLGA 裸露焊盘 包装：卷带（TR） 描述：LGA 6.00X6.00X0.80 MM, 0.50MM PI RF/IF，射频/中频和 RFID 射频放大器

Dual Path RF Switch with LNA and DVGA 3300MHz to 4000MHz

文件：1.798 Mbytes Page：30 Pages

High Speed Transistor Optocouplers

Description The HCPL05XX, and HCPL04XX optocouplers consist of an AlGaAs LED optically coupled to a high speed photodetector transistor housed in a compact 8-pin small outline package. A separate connection for the bias of the photodiode improves the speed by several orders of magnitude over con

Single Channel, High Speed Optocouplers

Description These diode-transistor optocouplers use an insulating layer between a LED and an integrated photodetector to provide electrical insulation between input and output. Separate connections for the photodiode bias and output-transistor collector increase the speed up to a hundred times th

Small Outline, 5 Lead, High Speed Optocouplers

Description These small outline high CMR, high speed, diode-transistor optocouplers are single channel devices in a five lead miniature footprint. They are electrically equivalent to the following Agilent optocouplers: The SO-5 JEDEC registered (MO-155) package outline does not require “through

Single Channel, High Speed Optocouplers

Description These diode-transistor optocouplers use an insulating layer between a LED and an integrated photodetector to provide electrical insulation between input and output. Separate connections for the photodiode bias and output-transistor collector increase the speed up to a hundred times th

Single Junction Gull Wing Circulator 950 MHz-956 MHz

文件：133.29 Kbytes Page：3 Pages