Free Time Delay Setting CMOS Voltage Detector (Reset) IC

General Description ROHM's BD52xx-2M and BD53xx-2M series are highly accurate, low current consumption Voltage Detector ICs with a capacitor controlled time delay. The lineup includes N-channel open drain output (BD52xx-2M) and CMOS output (BD53xx-2M) so that the users can select depending o

Free Time Delay Setting CMOS Voltage Detector (Reset) IC

General Description ROHM's BD52xx-2M and BD53xx-2M series are highly accurate, low current consumption Voltage Detector ICs with a capacitor controlled time delay. The lineup includes N-channel open drain output (BD52xx-2M) and CMOS output (BD53xx-2M) so that the users can select depending o

Free Time Delay Setting CMOS Voltage Detector (Reset) IC

文件：2.87104 Mbytes Page：24 Pages

Free Time Delay Setting CMOS Voltage Detector (Reset) IC

文件：2.87104 Mbytes Page：24 Pages

Nano Energy™ 延迟时间自由设置型CMOS电压检测器（复位）IC

Free Time Delay Setting CMOS Voltage Detector (Reset) IC

文件：2.87104 Mbytes Page：24 Pages

Nano Energy™ 延迟时间自由设置型 CMOS复位IC

2.5 V to 5.5 V, 115 uA, Parallel Interface Single Voltage-Output 8-/10-/12-Bit DACs

GENERAL DESCRIPTION The AD5330/AD5331/AD5340/AD53411 are single 8-/10-/12- bit DACs. They operate from a 2.5 V to 5.5 V supply consuming just 115 μA at 3 V and feature a power-down mode that further reduces the current to 80 nA. The devices incorporate an on-chip output buffer that can drive the

2.5 V to 5.5 V, 230uA, Parallel Interface Dual Voltage-Output 8-/10-/12-Bit DACs

GENERAL DESCRIPTION The AD5332/AD5333/AD5342/AD5343 are dual 8-, 10-, and 12-bit DACs. They operate from a 2.5 V to 5.5 V supply consuming just 230 µA at 3 V, and feature a power-down pin, PD that further reduces the current to 80 nA. These devices incorporate an on-chip output buffer that can dr

2.5 V to 5.5 V, 120 uA, 2-Wire Interface, Voltage Output 8-/10-/12-Bit DACs

GENERAL DESCRIPTION The AD5301/AD5311/AD5321 are single 8-bit, 10-bit, and 12-bit buffered voltage-output DACs that operate from a single 2.5 V to 5.5 V supply, consuming 120 µA at 3 V. The on-chip output amplifier allows rail-to-rail output swing with a slew rate of 0.7 V/µs. It uses a 2-wire (I

20 (7/28) AWG Tinned Copper

文件：411.7 Kbytes Page：4 Pages

DynaForceTM 120 and 160 Amp Alternators

文件：1.14574 Mbytes Page：4 Pages