Automotive Ground Sense Comparators

●General Description BA2903Yxxx-C/BA2901Yxx-C, integrate two or four independent high gain voltage comparator. Some features are the wide operating voltage that is 2V to 36V and low supply current. BA2903Yxxx-C, BA2901Yxx-C are manufactured for automotive requirements of engine control unit,

Automotive Ground Sense Comparators

●General Description BA2903Yxxx-C/BA2901Yxx-C, integrate two or four independent high gain voltage comparator. Some features are the wide operating voltage that is 2V to 36V and low supply current. BA2903Yxxx-C, BA2901Yxx-C are manufactured for automotive requirements of engine control unit,

Automotive Ground Sense Comparators

文件：825.55 Kbytes Page：32 Pages

Automotive Comparators:Ground Sense

文件：382.57 Kbytes Page：17 Pages

Standard Open-Collector Comparator

Automotive Ground Sense Comparators

文件：1.4914 Mbytes Page：34 Pages

Automotive Ground Sense Comparators

文件：825.55 Kbytes Page：32 Pages

Automotive Ground Sense Comparators

文件：825.55 Kbytes Page：32 Pages

车载用接地检测比较器

Automotive Ground Sense Comparators

文件：825.55 Kbytes Page：32 Pages

Automotive Ground Sense Comparators

文件：825.55 Kbytes Page：32 Pages

Automotive Ground Sense Comparators

文件：531.48 Kbytes Page：27 Pages

Automotive Ground Sense Comparators

文件：825.55 Kbytes Page：32 Pages

Automotive Ground Sense Comparators

文件：825.55 Kbytes Page：32 Pages

HiFiBerry DAC HAT - Standard RCA

o Dedicated 192kHz/24bit high-quality Burr-Brown DAC for best sound quality o Hardware volume control. You can control the output volume using “alsamixer” or any application that supports ALSA mixer controls o Directly powered from the Raspberry Pi, no additional power supply o Ultra-low-noise

Insert Molded Coil

Features: 1. Plastic molded. 2. High reliability. 3. Low cost. Measurement: 1. Q and L measured with ½” long of TCW#16 soldered along the coil leads and with one end flush with the bottom of the coil then bent ¼” down from stand off at an angle of 90°. 2. L min. measured with core halfway ou

110 MHz Center Frequency

General Description KR 2901 is a 110 MHz bandpass filter. The filter has a typical 1 dB bandwidth of 16 MHz. Other passband frequencies are available. Please consult the factory. Features ● 110 MHz Center Frequency ● 16 MHz 1 dB Bandwidth ● SMA Connectors ● 50 Ω Source and Load

Size C Aluminum Box With Cover

Size C Aluminum Box Wit Cover

High Temperature Low Power Quad Voltage Comparators

Description This device consists of four independent precision voltage comparators. All these comparators are designed specifically to operate from a single power supply over a wide range of voltages. Operation from split power supplies is also possible. These comparators also have a unique