低功耗蓝牙 BLE5.0 SOC

具有8kb缓存和2线SWD调试接口的嵌入式48MHz的32位RISCMCU，包括用于嵌入式编程的512KB的FLash，128KB的SRAM(64KB的系统程序SRAM，64KB的数据SRAM) • 数据传输速率 125Kb/s， 500Kb/s， 1Mb/s and 2Mb/s\n• 跳频CSA#1和CSA#2\n• UART0 用于系统控制器\n• 每个管脚都能映射到不同的功能接口\n• 2.400-2.484 GHz， 具有GFSK\n• 输出功耗-28dBm到6.5dBm\n• 集成的PLL\n• 自动调整VCO和RX滤波器\n• 外部电压支持1.62-3.63V\n• Idd双向接收: 6mA\n• 低功耗模式(500ms wake up): 50uA\n• 低功耗模式(没有寄存器恢复的深度睡眠，通过RTC唤醒):1.5uA\n• 外部48M 晶振\n• 内部32KHz RC;

HIGH SPEED DIFFERENTIAL LINE DRIVERS AND RECEIVERS

DESCRIPTION The STLVDS050 is differential line drivers and receivers that use low-voltage differential signaling (LVDS) to achieve signaling rate as high as 400Mbps. The EIA/TIA-644 standard compliant electrical interface provides a minimum differential output voltage magnitude of 247 mV into a

HIGH SPEED DIFFERENTIAL LINE DRIVERS AND RECEIVERS

DESCRIPTION The STLVDS050 is differential line drivers and receivers that use low-voltage differential signaling (LVDS) to achieve signaling rate as high as 400Mbps. The EIA/TIA-644 standard compliant electrical interface provides a minimum differential output voltage magnitude of 247 mV into a

HIGH SPEED DIFFERENTIAL LINE DRIVERS AND RECEIVERS

DESCRIPTION The STLVDS050 is differential line drivers and receivers that use low-voltage differential signaling (LVDS) to achieve signaling rate as high as 400Mbps. The EIA/TIA-644 standard compliant electrical interface provides a minimum differential output voltage magnitude of 247 mV into a

HIGH SPEED DIFFERENTIAL LINE DRIVERS AND RECEIVERS

DESCRIPTION The STLVDS050 is differential line drivers and receivers that use low-voltage differential signaling (LVDS) to achieve signaling rate as high as 400Mbps. The EIA/TIA-644 standard compliant electrical interface provides a minimum differential output voltage magnitude of 247 mV into a

HIGH SIDE SMART POWER SOLID STATE RELAY

DESCRIPTION The VN05H is a monolithic devices made using SGS-THOMSON Vertical Intelligent Power Technology, intended for driving resistive or inductive loads with one side grounded. Built-in thermal shut-down protects the chip from over temperature and short circuit. The input control is 5V log