FAST TRANSIENT RESPONSE 5-A LOW-DROPOUT REGULATOR

Fast Transient Response 10-mA to 5-A Load Current Short Circuit Protection Maximum Dropout of 500-mV at 5-A Load Current Separate Bias (VB) and VIN Pins Available in Adjustable or Fixed Output Voltages 5-Pin Package Allows Kelvin Sensing of Load Voltage Reverse Current Protection desc

FAST TRANSIENT REPONSE 5-A LOW-DROPOUT REGULATOR

文件：265.51 Kbytes Page：13 Pages

FAST TRANSIENT RESPONSE 5A LOW-DROPOUT REGULATOR

文件：876.64 Kbytes Page：18 Pages

封装/外壳：TO-263-6，D²Pak（5 引线 + 接片），TO-263BA 包装：卷带（TR） 描述：IC REG LIN POS ADJ 5A DDPAK 集成电路（IC） 线性 + 开关稳压器

封装/外壳：TO-263-6，D²Pak（5 引线 + 接片），TO-263BA 包装：卷带（TR） 描述：IC REG LIN POS ADJ 5A DDPAK 集成电路（IC） 稳压器 - 线性

FAST TRANSIENT RESPONSE 5-A LOW-DROPOUT REGULATOR

Fast Transient Response 10-mA to 5-A Load Current Short Circuit Protection Maximum Dropout of 500-mV at 5-A Load Current Separate Bias (VB) and VIN Pins Available in Adjustable or Fixed Output Voltages 5-Pin Package Allows Kelvin Sensing of Load Voltage Reverse Current Protection desc

ROD SEALS

DESCRIPTION The BECA 385 profile is a U-ring type single acting rod seal with asymmetrical rubber lips for low-pressure applications. APPLICATIONS Material handling - Lifting Presses Hydraulic cylinders

Timer/Counter with Memory

• EEPROM Memory • Easy DIP Switch Setup • Three Adjustable Presets with Internal Cycle Totalizer • Dual LED Display with Cycle Progress • Selectable SEC, MIN, or HRS Ranges • Nine Timing Ranges 0 to 9.99, 99.9, 999, or HR:MIN, MIN:SEC to 99:59 • Two Counting Ranges 0 to 9999 or 10 to 99990

Multifunction, Multi Range Timer Counter

• Dual Display, 4 digit, 7 segment LED • LED Status Indicator: Relay 1, Relay 2, Seconds, Minutes, Hours • 2 Setpoints • Programmable Input Scaling • Down Counting for Timer, Up/Down Counting for Counter • Batch Counting

Micropower Voltage Reference Diode

General Description The AME385-1.2 is a micropower 2-terminal band-gap voltage regulator diode. It operates over a 15µA to 20mA current range. Each circuit is trimmed at wafer sort to provide a ±0.2 and ±0.5 initial tolerance. The design of the AME385-1.2 allows for a large range of load capacita

CIRCUIT PROTECTORS

文件：88.6 Kbytes Page：2 Pages