1 Features

• Qualified for automotive applications

• AEC-Q100 qualified with the following results:

– Device temperature grade 1: 40°C to +125°C

ambient operating temperature range

– Device HBM ESD Classification Level 2

– Device CDM ESD Classification Level C6

• No direction-control signal needed

• Maximum data rates:

– 24Mbps (push pull)

– 2Mbps (open drain)

• 1.65V to 3.6V on A port and 2.3V to 5.5V on B port

(VCCA ≤ VCCB)

• No power-supply sequencing required – VCCA or

VCCB can be ramped first

• ESD protection exceeds JESD 22:

– A port:

• 2000V Human-Body Model (A114-B)

• 500V Charged-Device Model (C101)

– B port:

• 5000V Human-Body Model (A114-B)

• 500V Charged-Device Model (C101)

2 Applications

• Automotive infotainment, advance driver

assistance systems (ADAS)

• Isolates and level translates between main

processor and peripheral modules

• I2C or 1-wire voltage-level translation

3 Description

This 4-bit non-inverting translator uses two separate

configurable power-supply rails. The A port is

designed to track VCCA. VCCA accepts any supply

voltage from 1.65V to 3.6V. VCCA must be less than or

equal to VCCB. The B port is designed to track VCCB.

VCCB accepts any supply voltage from 2.3V to 5.5V.

This allows for low-voltage bidirectional translation

between any of the 1.8V, 2.5V, 3.3V, and 5V voltage

nodes.

When the output-enable (OE) input is low, all outputs

are placed in the high-impedance state.

The TXS0104V-Q1 is designed so that the OE input

circuit is supplied by VCCA.

For the high-impedance state during power up or

power down, tie OE to GND through a pull-down

resistor; the current-sourcing capability of the driver

determines the minimum value of the resistor.