FEATURES

· Low and Flat ON-State Resistance (ron)

Characteristics Over Operating Range

(ron = 3 W Typ)

· 0- to 10-V Switching on Data I/O Ports

· Bidirectional Data Flow With Near-Zero

Propagation Delay

· Low Input/Output Capacitance Minimizes

Loading and Signal Distortion

(Cio(OFF) = 20 pF Max, B Port)

· VCC Operating Range From 4.75 V to 5.25 V

· Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

· ESD Performance Tested Per JESD 22

– 2000-V Human-Body Model

(A114-B, Class II)

– 1000-V Charged-Device Model (C101)

· Supports Both Digital and Analog

Applications: PCI Interface, Differential Signal

Interface, Memory Interleaving, Bus Isolation,

Low-Distortion Signal Gating

DESCRIPTION/ORDERING INFORMATION

The TS5N214 is a high-bandwidth FET bus switch utilizing a charge pump to elevate the gate voltage of the pass

transistor, providing a low and flat ON-state resistance (ron). The low and flat ON-state resistance allows for

minimal propagation delay and supports rail-to-rail switching on the data input/output (I/O) ports. The device also

features low data I/O capacitance to minimize capacitive loading and signal distorion on the data bus. Specifically

designed to support high-bandwidth applications, the TS5N214 provides an optimized interface solution ideally

suited for broadband communications, networking, and data-intensive computing systems.

The TS5N214 is a 2-bit 1-of-4 multiplexer/demultiplexer with separate output-enable (1OE, 2OE) inputs. The

select (S0, S1) inputs control the data path of the multiplexer/demultiplexer. When OE is low, the

multiplexer/demultiplexer is enabled and the A port is connected to the B port, allowing bidirectional data flow

between ports. When OE is high, the multiplexer/demultiplexer is disabled and a high-impedance state exists

between the A and B ports.

This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry prevents damaging

current backflow through the device when it is powered down. The device has isolation during power off.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.