Qualified for Automotive Applications

Direct Upgrades to TL05x, TL07x, and

TL08x BiFET Operational Amplifiers

Greater Than 2× Bandwidth (10 MHz) and

3× Slew Rate (45 V/μs) Than TL07x

Ensured Maximum Noise Floor

17 nV/√Hz

On-Chip Offset Voltage Trimming for

Improved DC Performance

Wider Supply Rails Increase Dynamic

Signal Range to ±19 V

description/ordering information

The TLE207x series of JFET-input operational amplifiers more than double the bandwidth and triple the slew

rate of the TL07x and TL08x families of BiFET operational amplifiers. Texas Instruments Excalibur process

yields a typical noise floor of 11.6 nV/√Hz, 17-nV/√Hz ensured maximum, offering immediate improvement in

noise-sensitive circuits designed using the TL07x. The TLE207x also has wider supply voltage rails, increasing

the dynamic signal range for BiFET circuits to ±19 V. On-chip zener trimming of offset voltage yields precision

grades for greater accuracy in dc-coupled applications. The TLE207x are pin-compatible with lower

performance BiFET operational amplifiers for ease in improving performance in existing designs.

BiFET operational amplifiers offer the inherently higher input impedance of the JFET-input transistors, without

sacrificing the output drive associated with bipolar amplifiers. This makes them better suited for interfacing with

high-impedance sensors or very low-level ac signals. They also feature inherently better ac response than

bipolar or CMOS devices having comparable power consumption.

The TLE207x family of BiFET amplifiers are Texas Instruments highest performance BiFETs, with tighter input

offset voltage and ensured maximum noise specifications. Designers requiring less stringent specifications but

seeking the improved ac characteristics of the TLE207x should consider the TLE208x operational amplifier

family.

Because BiFET operational amplifiers are designed for use with dual power supplies, care must be taken to

observe common-mode input voltage limits and output swing when operating from a single supply. DC biasing

of the input signal is required and loads should be terminated to a virtual ground node at mid-supply. Texas

Instruments TLE2426 integrated virtual ground generator is useful when operating BiFET amplifiers from single

supplies.