FEATURES

· Member of the Texas Instruments Widebus™

Family

· EPIC™ (Enhanced-Performance Implanted

CMOS) Submicron Process

· DOC™ (Dynamic Output Control) Circuit

Dynamically Changes Output Impedance,

Resulting in Noise Reduction Without Speed

Degradation

· Dynamic Drive Capability Is Equivalent to

Standard Outputs With IOH and IOL of ±24 mA

at 2.5-V VCC

· Overvoltage-Tolerant Inputs/Outputs Allow

Mixed-Voltage-Mode Data Communications

· Ioff Supports Partial-Power-Down Mode

Operation

· Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

· Package Options Include Plastic Thin Shrink

Small-Outline (DGG) and Thin Very

Small-Outline (DGV) Packages

DESCRIPTION

A Dynamic Output Control (DOC™) circuit is implemented, which, during the transition, initially lowers the output

impedance to effectively drive the load and, subsequently, raises the impedance to reduce noise. Figure 1 shows

typical VOL vs IOL and VOH vs IOH curves to illustrate the output impedance and drive capability of the circuit. At

the beginning of the signal transition, the DOC circuit provides a maximum dynamic drive that is equivalent to a

high-drive standard-output device. For more information, refer to the TI application reports, AVC Logic Family

Technology and Applications, literature number SCEA006, and Dynamic Output Control (DOC™) Circuitry

Technology and Applications, literature number SCEA009.

This 16-bit bus transceiver and register is operational at 1.2-V to 3.6-V VCC, but is designed specifically for

1.65-V to 3.6-V VCC operation.

The SN74AVC16646 can be used as two 8-bit transceivers or one 16-bit transceiver. Data on the A or B bus is

clocked into the registers on the low-to-high transition of the appropriate clock (CLKAB or CLKBA) input. Figure 2

illustrates the four fundamental bus-management functions that can be performed with the SN74AVC16646.

Output-enable (OE) and direction-control (DIR) inputs are provided to control the transceiver functions. In the

transceiver mode, data present at the high-impedance port may be stored in either register or in both. The

select-control (SAB and SBA) inputs can multiplex stored and real-time (transparent mode) data.

The circuitry used for select control eliminates the typical decoding glitch that occurs in a multiplexer during the

transition between stored and real-time data. DIR determines which bus receives data when OE is low. In the

isolation mode (OE high), A data may be stored in one register and/or B data may be stored in the other register.

When an output function is disabled, the input function still is enabled and may be used to store and transmit

data. Only one of the two buses, A or B, can be driven at a time.

To ensure the high-impedance state during power up or power down, OE should be tied to VCC through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs,

preventing damaging current backflow through the device when it is powered down.

The SN74AVC16646 is characterized for operation from –40°C to 85°C.