FEATURES

· Member of the Texas Instruments Widebus™

Family

· Optimized for 1.8-V Operation and Is 3.6-V I/O

Tolerant to Support Mixed-Mode Signal

Operation

· Ioff Supports Partial-Power-Down Mode

Operation

· Sub-1-V Operable

· Max tpd of 2.8 ns at 1.8 V

· Low Power Consumption, 20-mA Max ICC

· ±8-mA Output Drive at 1.8 V

· Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

· ESD Protection Exceeds JESD 22

– 2000-V Human-Body Model (A114-A)

– 200-V Machine Model (A115-A)

– 1000-V Charged-Device Model (C101)

DESCRIPTION/ORDERING

INFORMATION

This 16-bit edge-triggered D-type flip-flop is

operational at 0.8-V to 2.7-V VCC, but is designed

specifically for 1.65-V to 1.95-V VCC operation.

The SN74AUC16374 is particularly suitable for

implementing buffer registers, I/O ports, bidirectional

bus drivers, and working registers. It can be used as

two 8-bit flip-flops or one 16-bit flip-flop. On the

positive transition of the clock (CLK) input, the Q

outputs of the flip-flop take on the logic levels set up

at the data (D) inputs.

A buffered output-enable (OE) input can be used to place the eight outputs in either a normal logic state (high or

low logic levels) or the high-impedance state. In the high-impedance state, the outputs neither load nor drive the

bus lines significantly. The high-impedance state and increased drive provide the capability to drive bus lines

without interface or pullup components.

OE does not affect internal operations of the latch. Old data can be retained or new data can be entered while

the outputs are in the high-impedance state.