FEATURES

· Typically Meets or Exceeds ANSI

TIA/EIA-644-1995 Standard

· Operates From a Single 2.4-V to 3.6-V Supply

· Signaling Rates up to 400 Mbit/s

· Bus-Terminal ESD Exceeds 12 kV

· Low-Voltage Differential Signaling With Typical

Output Voltages of 285 mV and a 100-W

Load

· Propagation Delay Times

· Driver: 1.7-ns Typical

· Receiver: 3.7-ns Typical

· Driver: 25-mW Typical

· Receiver: 60-mW Typical

· Power Dissipation at 200 MHz

· Driver: 25-mW Typical

· Receiver: 60-mW Typical

· LVTTL Input Levels Are 5-V Tolerant

· Receiver Maintains High Input Impedance

· Receiver Has Open-Circuit Fail Safe

· Available in Thin Shink Outline Packaging

With 20-mil Lead Pitch

DESCRIPTION

The SN65LVDS1050 is similar to the SN65LVDS050

except that it is characterized for operation with a lower

supply voltage range and packaged in the thin shrink

outline package for portable battery-powered applications.

The differential line drivers and receivers use low-voltage differential signaling (LVDS) to achieve signaling rates as

high as 400 Mbps. The drivers provide a minimum differential output voltage magnitude of 247 mV into a 100-W load

and receipt of 100-mV signals with up to 1 V of ground potential difference between a transmitter and receiver.

The intended application of this device and signaling technique is for point-to-point baseband data transmission

over controlled impedance media of approximately 100-W characteristic impedance. The transmission media may

be printed-circuit board traces, backplanes, or cables. Note: The ultimate rate and distance of data transfer is

dependent upon the attenuation characteristics of the media, the noise coupling to the environment and other

application-specific characteristics.

The SN65LVDS1050 is characterized for operation from -40°C to 85°C.