1 Features

• AEC-Q100 qualified for automotive applications:

– Temperature grade 1: –40°C to +125°C, TA

• Functional Safety-Compliant Targeted

– Developed for functional safety applications

– Documentation to aid ISO26262 system design

– Systematic integrity up to ASIL D

– Hardware integrity up to ASIL B

• 5V to 35V (40V abs. max) operating range

• H-bridge or dual-channel half-bridge gate drivers

– Smart gate drive architecture

– Tripler charge pump for 100% PWM

– Wide common mode current shunt amplifier

• 1 Integrated half-bridge with IOUT max 8A (RDSON

HS +LS FET = 155mΩ)

• 1 Integrated half-bridge with IOUT max 7A (RDSON

HS +LS FET = 185mΩ)

• 2 Integrated half-bridges with IOUT max 4A (RDSON

HS +LS FET = 440mΩ)

• 2 Integrated half-bridges with IOUT max 1.3A load

(RDSON HS +LS FET = 1540mΩ)

• 1 Configurable integrated high-side driver as lamp

or LED driver with IOUT Max 1.5/0.5A (RDSON =

0.4/1.2Ω)

• 5 Configurable integrated high-side drivers for

0.5/0.25A load (RDSON = 1.2Ω)

• 1 External MOSFET gate driver for charge of

electrochromic glass

• 1 Integrated low-side FET for discharge of

electrochromic glass

• Internal 10bit PWM generator for high-side drivers

• All high-side drivers support a low- or high- current

threshold constant current mode to drive a wide

range of LED modules

• 1 external MOSFET gate driver for heater

– Offline open load detection

– VDS monitoring of low RDSON MOSFET for

short-circuit detection

• Integrated driver output features current regulation

(ITRIP)

• Muxable sense output (IPROPI)

– Internal current sensing with proportional

current output (IPROPI)

– Advanced die temperature monitoring with

multiple thermal clusters

– Motor supply voltage monitor

• Protection and diagnostic features with

configurable fault behavior

– Load diagnostics in both the off-state and onstate

to detect open load and short-circuit

– Overcurrent and over temperature protection

• Device Comparison Table

2 Applications

• Door module

• Body control modules

• Zonal module

3 Description

The DRV8000-Q1 device integrates multiple door

control specific functions: driving and diagnosing

motor (inductive), resistive and capacitive loads,

driving a lamp or LEDs, drive MOSFETs for special

loads such as heating element or electrochromic

elements. These drivers include protection features

for offline and active diagnostics such as under

and over voltage monitors, offline open load and

short-circuit diagnostics, and zone-based thermal

monitoring and shutdown protection. The device

features two half-bridge gate drivers, 6 integrated halfbridges

(2 high-side alternate modes), 6 integrated

high-side drivers, one external high-side gate driver

for heater, one external high-side gate driver for

electrochromic charge and one integrated low-side

driver for electrochromic load discharge. The halfbridge,

high-side, heater and gate drivers have

PWM input control configuration, sensing, diagnostics

and device system protection. There is a dedicated

internal programmable PWM generators for each

high-side driver. Proportional current sense pin output

is available for all integrated drivers, along with a

robust and flexible current shunt amplifier for the gate

driver.