1FEATURES

• Qualified for Automotive Applications

• Member of the Texas Instruments Widebus™

Family

• DOC™ Circuitry Dynamically Changes Output

Impedance, Resulting in Noise Reduction

Without Speed Degradation

• Dynamic Drive Capability Is Equivalent to

Standard Outputs With IOH and IOL of ±24 mA at

2.5-V VCC

• Control Inputs VIH/VIL Levels Are Referenced to

VCCB Voltage

• If Either VCC Input Is at GND, Both Ports Are in

the High-Impedance State

• Overvoltage-Tolerant Inputs/Outputs Allow

Mixed-Voltage-Mode Data Communications

• Ioff Supports Partial-Power-Down Mode

Operation

• Fully Configurable Dual-Rail Design Allows

Each Port to Operate Over Full 1.4-V to 3.6-V

Power-Supply Range

• Latch-Up Performance Exceeds 100 mA Per

JESD 78, Class II

• ESD Protection Exceeds JESD 22

– 2000-V Human-Body Model (A114-A)

– 200-V Machine Model (A115-A)

– 750-V Charged-Device Model (C101)

DESCRIPTION

This 16-bit (dual-octal) noninverting bus transceiver uses two separate configurable power-supply rails. The

A port is designed to track VCCA. VCCA accepts any supply voltage from 1.4 V to 3.6 V. The B port is designed to

track VCCB. VCCB accepts any supply voltage from 1.4 V to 3.6 V. This allows for universal low-voltage

bidirectional translation between any of the 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes.

The SN74AVCB164245 is designed for asynchronous communication between data buses. The device transmits

data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the

direction-control (DIR) input. The output-enable (OE) input can be used to disable the outputs so the buses are

effectively isolated.

The SN74AVCB164245 is designed so that the control pins (1DIR, 2DIR, 1OE, and 2OE) are supplied by VCCB.

To ensure the high-impedance state during power up or power down, OE should be tied to VCCB through a pullup

resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs,

preventing damaging current backflow through the device when it is powered down. If either VCC input is at GND,

both ports are in the high-impedance state.