1FEATURES

2• Maximum Sample Rate: 100 MSPS

• Designed for Low Power:

– 80 mW per channel at 100 MSPS

• SNR: 70.6 dBFS

• SFDR: 85 dBc at 10 MHz, 100 MSPS

• Serial LVDS ADC Data Outputs:

– One- or Two-Wire Serialized LVDS Outputs

per Channel

– One-Wire Interface:

Up to 80 MSPS Sample Rate

– Two-Wire Interface:

Up to 100 MSPS Sample Rate

• Digital Processing Block:

– Programmable FIR Decimation Filter and

Oversampling to Minimize Harmonic

Interference

– Programmable IIR High-Pass Filter to

Minimize DC Offset

– Programmable Digital Gain: 0 dB to 12 dB

• Low-Frequency Noise Suppression Mode

• Programmable Mapping Between ADC Input

Channels and LVDS Output Pins signal•

Channel Averaging Mode

• Variety of LVDS Test Patterns to Verify

Data Capture by FPGA or Receiver

• Package: 12-mm × 12-mm QFP-80

APPLICATIONS

• Ultrasound Imaging

• Communication Applications

• Multichannel Data Acquisition

DESCRIPTION

The ADS5295 is a low-power, 12-bit, 100-MSPS, 8-

channel analog-to-digital converter (ADC). Low power

consumption and integration of multiple channels in a

compact package make the device attractive for very

high channel count data acquisition systems.

Serial low-voltage differential signaling (LVDS)

outputs reduce the number of interface lines and

enable high system integration. The ADC digital data

can be output over one or two wires of LVDS pins per

channel. At high sample rates, the two-wire interface

helps keep the serial data rate low, allowing low-cost

field-programmable gate array (FPGA)-based

receivers to be used.

The device integrates an internal reference trimmed

to accurately match across devices. Best

performance is expected to be achieved through the internal reference mode. However, the device can be

driven with external references as well.

Several digital functions that are commonly used in systems are included in the device. These functions

include a low-frequency suppression mode, digital

filtering options, and programmable mapping.

For low input frequency applications, the low-

frequency noise suppression mode enables noise

suppression at low frequencies and improves signal•

to-noise ratio (SNR) in the 1-MHz band near dc by

approximately 3 dB. Digital filtering options include

low-pass, high-pass, and band-pass digital filters, as

well as dc offset removal filters. The device also

provides programmable mapping of the LVDS output

pins and analog input channels. For applications

where the 12-bit ADC SNR is not required, the

ADS5295 can be configured as an 8-channel, 10-bit

ADC with 10x LVDS serialization to reduce the output

data rate.

The device is available in a 12-mm × 12-mm QFP-80

package. The ADS5295 is specified over the –40°C

to +85°C operating temperature range.