1 Features

• AEC-Q100 qualified for automotive applications:

– Temperature grade 1: –40°C to +125°C, TA

• 4.5V to 35V (40V abs. max) operating range

• H-bridge or dual-channel half-bridge gate drivers

– Smart gate drive architecture

– Tripler charge pump for 100% PWM

– Wide common mode current shunt amplifier

• 1 Integrated Half-bridge with IOUT Max 8A (RDSON

= 132mΩ, 66mΩ per FET)

• 1 Integrated Half-bridge with IOUT Max 7A (RDSON

= 160mΩ, 80mΩ per FET)

• 2 Integrated Half-bridges with IOUT Max 4A (RDSON

= 400mΩ, 200mΩ per FET)

• 2 Integrated Half-bridges with IOUT Max 1.3A load

(RDSON = 1500mΩ, 750mΩ per FET)

• 1 Configurable Integrated High-side driver as

Lamp or LED driver with IOUT Max 1.5/0.5A (RDSON

= 0.4/1.5Ω)

• 5 Integrated High-side drivers for 0.5/0.25A load

(RDSON = 1.5Ω)

– 1 High-side driver to supply electro chromic

(EC) glass MOSFET

• 1 external MOSFET gate driver for charge of

electro chromic glass

• 1 integrated Low-side FET for discharge of electro

chromic glass

• Internal 10bit PWM generator for high-side drivers

• All high-side drivers support a low- or high- current

threshold constant current mode to drive a wide

range of LED modules

• 1 external MOSFET gate driver for heater

– Offline open load detection

– VDS monitoring of low RDSON MOSFET for short

circuit detection

• Integrated driver output features Current regulation

(ITRIP)

• Muxable sense output (IPROPI)

– Internal current sensing with proportional

current output (IPROPI)

– Advanced die temperature monitoring with

multiple thermal clusters

– Scaled supply voltage output

• Protection and diagnostic features with

configurable fault behavior

– Load diagnostics in both the off-state and onstate

to detect open load and short circuit

– Over current and over temperature protection

• Device Comparison Table

2 Applications

• Door module

• Body control modules

• Zonal module

3 Description

The DRV8000-Q1 device integrates multiple types of

drivers intended for multiple functions: driving and

diagnosing motor (inductive), resistive and capacitive

loads. The device features two half-bridge gate

drivers, 6 integrated half-bridges, 6 integrated highside

drivers, one external high-side gate driver

for heater, one external high-side gate driver for

electrochromic charge and one integrated low-side

driver for electrochromic load discharge. Each

individual driver has PWM input control options,

sensing and diagnostics, along with device system

protection and diagnostics. There are also dedicated

programmable PWM generators for each high-side

driver. Proportional current sense pin output is

available for all integrated drivers, along with a robust

and flexible current shunt amplifier for the gate driver.

The high-side and low-side drivers can be used to

drive MOSFETs for special loads such as heating

element or electro-chromic elements. These drivers

include offline and active diagnostics.

The device provides protection features such as

under and over voltage monitors, offline open load

and short circuit diagnostics, and zone-based thermal

monitoring and shutdown protection.