200 mA output current with thermal shutdown and output current limiter, 3.1 MHz,36 V, BiCMOS dual operational amplifier

Features • Wide supply voltage: 4 V - 36 V • High output current 200 mA • Rail-to-rail output, low rail input • Gain bandwidth product: 3.1 MHz • High slew rate: 2 V/μs • Internal thermal shutdown & output current limiter • Enhanced RF noise immunity • High tolerance to ESD: 4 kV HBM • Ex

200 mA输出电流（带热关断和输出限流器）、3.1 MHz@36 V BiCMOS双运算放大器

TSB582是一种单位增益稳定型双运算放大器，具有高电压和高电流能力，内置防止超温和电流过载的保护机制。此外，TSB582还增强了抵抗ESD和RF噪声干扰的能力。\n\n 通常每通道可输出最高200 mA电流，以驱动低电阻感性负载（如分角器、线路输出电缆，以及压电式执行器）。\n\n TSB582的两个大电流输出放大器可以直接驱动采取桥接模式或并联连接的负载，使输出的受电/供电电流增加一倍。此外，TSB582有两种空间节约型封装选项 - SO8封装具有裸露焊盘，而DFN8采用表面可湿和裸露焊盘。这两种封装均能承受-40 °C至+125 °C的工作温度范围，符合汽车应用要求。 • 宽电源电压：4 V - 36 V \n• 高输出电流：200 mA \n• 轨对轨输出，低电源轨输入 \n• 增益带宽积：3.1 MHz \n• 高转换率：2 V/µs \n• 内置热关断&输出电流限制功能 \n• 增强了抵抗RF噪声的能力 \n• 出色的耐静电性能：4 kV HBM• 更宽的温度范围：-40°C 至 125 °C \n• 车规级 \n• 低噪声：45 nV/√Hz @ 1 kHz \n• Icc（典型值） = 2.3 mA \n• 单位增益稳定 \n• 低偏移电压：最高2.4 mV (25°C)/3 mV（全温度范围） \n• 低输入偏置电流 \n• 封装：SO8和DFN;

丝印代码：K2H；200 mA output current with thermal shutdown and output current limiter, 3.1 MHz,36 V, BiCMOS dual operational amplifier

Features • Wide supply voltage: 4 V - 36 V • High output current 200 mA • Rail-to-rail output, low rail input • Gain bandwidth product: 3.1 MHz • High slew rate: 2 V/μs • Internal thermal shutdown & output current limiter • Enhanced RF noise immunity • High tolerance to ESD: 4 kV HBM • Ex

丝印代码：K2H；200 mA output current with thermal shutdown and output current limiter, 3.1 MHz,36 V, BiCMOS dual operational amplifier

Features • Wide supply voltage: 4 V - 36 V • High output current 200 mA • Rail-to-rail output, low rail input • Gain bandwidth product: 3.1 MHz • High slew rate: 2 V/μs • Internal thermal shutdown & output current limiter • Enhanced RF noise immunity • High tolerance to ESD: 4 kV HBM • Ex

丝印代码：K2I；200 mA output current with thermal shutdown and output current limiter, 3.1 MHz,36 V, BiCMOS dual operational amplifier

Features • Wide supply voltage: 4 V - 36 V • High output current 200 mA • Rail-to-rail output, low rail input • Gain bandwidth product: 3.1 MHz • High slew rate: 2 V/μs • Internal thermal shutdown & output current limiter • Enhanced RF noise immunity • High tolerance to ESD: 4 kV HBM • Ex

丝印代码：K2I；200 mA output current with thermal shutdown and output current limiter, 3.1 MHz,36 V, BiCMOS dual operational amplifier

Features • Wide supply voltage: 4 V - 36 V • High output current 200 mA • Rail-to-rail output, low rail input • Gain bandwidth product: 3.1 MHz • High slew rate: 2 V/μs • Internal thermal shutdown & output current limiter • Enhanced RF noise immunity • High tolerance to ESD: 4 kV HBM • Ex

Low Cost Sample/Hold Amplifier

PRODUCT DESCRIPTION The AD582 is a low cost integrated circuit sample and hold amplifier consisting of a high performance operational amplifier, a low leakage analog switch and a JFET integrating amplifier - all fabricated on a single monolithic chip. An external holding capacitor, connected to t

Silicon RF Switching Diode

● For low-loss VHF band switching in TV/VTR tuners

Two Channel Direct Drive Speech Controller?

INTRODUCTION SNC582 is a two-channel voice synthesizer IC with PWM direct drive circuit. It built-in a 4-bit tiny controller with one 4-bit input port and two 4-bit I/O ports. By programming through the tiny controller in SNC582, user’s varied applications including voice section combination, key

3.3-V PHASE-LOCK LOOP CLOCK DRIVER WITH DIFFERENTIAL LVPECL CLOCK INPUTS

文件：143.57 Kbytes Page：10 Pages

3.3-V PHASE-LOCK LOOP CLOCK DRIVER WITH DIFFERENTIAL LVPECL CLOCK INPUTS

文件：143.57 Kbytes Page：10 Pages