MICROPOWER DUAL CMOS VOLTAGE COMPARATORS

DESCRIPTION The TS393 is a micropower CMOS dual voltage comparator with extremely low consumption of 9µA typ / comparator (20 times less than bipolar LM393). Similar performances are offered by the dual micropower comparator TS3702 with a push-pull CMOS output. Thus response times remain sim

Micropower dual CMOS voltage comparators

文件：155.1 Kbytes Page：12 Pages

MICROPOWER DUAL CMOS VOLTAGE COMPARATORS

DESCRIPTION The TS393 is a micropower CMOS dual voltage comparator with extremely low consumption of 9µA typ / comparator (20 times less than bipolar LM393). Similar performances are offered by the dual micropower comparator TS3702 with a push-pull CMOS output. Thus response times remain sim

Micropower dual CMOS voltage comparators

文件：155.1 Kbytes Page：12 Pages

High Voltage Transistors(NPN)

High Voltage Transistors NPN Silicon

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS The LM393 series are dual independent precision voltage comparators capable of single or split supply operation. These devices are designed to permit a common mode range–to–ground level with single supply operation. Input offset voltage specifications

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS The LM393 series are dual independent precision voltage comparators capable of single or split supply operation. These devices are designed to permit a common mode range–to–ground level with single supply operation. Input offset voltage specifications

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS The LM393 series are dual independent precision voltage comparators capable of single or split supply operation. These devices are designed to permit a common mode range–to–ground level with single supply operation. Input offset voltage specifications

BROADBAND PUSH-PULL RF POWER TRANSISTOR NPN SILICON

The RF Line NPN Silicon Push-Pull RF Power Transistor . . . designed primarily for wideband large–signal output and driver amplifier stages in the 30 to 500 MHz frequency range. • Specified 28 Volt, 500 MHz Characteristics — Output Power = 100 W Typical Gain = 9.5 dB (Class A