Three phase motor driver with BLDC back EMF commutation hallFX??and current sensing

文件：987.92 Kbytes Page：44 Pages

3-Phase Gatedriver ICs

The TMC603 is a 3-phase BLDC gate driver for Robotics, Drones and other dynamic applications. The device is capable driving up to a gate current of 150mA. The TMC603 has comprehensiv diagnostic functions including GND protection, break before make logic, slope control and current sensing via MOSFET · brake before make \n· short to GND detection \n· slope control \n· current sensing via MOSFET ;

Intelligent Triple Stepper Motor Controller

文件：886.68 Kbytes Page：37 Pages

封装/外壳：52-VFQFN 裸露焊盘 功能：控制器 - 换向，方向管理 包装：管件 描述：IC MOTOR DRIVER 3.3V-5V 52QFN 集成电路（IC） 电机驱动器，控制器

PHASE CONTROL THYRISTOR

PHASE CONTROL THYRISTOR Repetitive voltage up to 1600 V Mean on-state current 720 A Surge current 8.8 kA

DPAK SURFACE MOUNT SUPER FAST RECOVERY RECTIFIER(VOLTAGE - 200 to 600 Volts CURRENT - 6.0 Amperes)

VOLTAGE 200 to 600 Volts CURRENT 6.0 Amperes FEATURES • Superfast recovery times-epitaxial construction. • Low forward voltage, high current capability. • Exceeds environmental standards of MIL-S-19500/228. • Hermetically sealed. • Low leakage. • High surge capability. • Plastic package ha

SUPER FAST RECOVERY RECTIFIER(VOLTAGE - 200 to 600 Volts CURRENT - 6.0 Amperes)

SUPER FAST RECOVERY RECTIFIER VOLTAGE - 200 to 600 Volts CURRENT - 6.0 Amperes FEATURES • For thorough hole applications • Low profile package • Built-in strain relief • Easy pick and place • Superfast recovery times for high efficiency • Plastic package has Underwriters

TrenchMOS/ Schottky diode array Three phase brushless d.c. motor driver

GENERAL DESCRIPTION Six n-channel, enhancement mode, logic level, field-effect power transistors and six schottky diodes configured as three half-bridges. This device has low on-state resistance and fast switching. The intended application is in computer disk and tape drives as a three phase brus

P-CHANNEL MOS FET 6-PIN 2 CIRCUITS

P-CHANNEL MOS FET (6-PIN 2 CIRCUITS) The µPA603T is a mini-mold device provided with two MOS FET circuits. It achieves high-density mounting and saves mounting costs. FEATURES • Two MOS FET circuits in package the same size as SC-59 • Complement to µPA602T • Automatic mounting