丝印代码：T4581；DUAL LOW-NOISE HIGH-DRIVE OPERATIONAL AMPLIFIER

Equivalent Input Noise Voltage 5 nV/√Hz Typ at 1 kHz Unity-Gain Bandwidth . . . 10 MHz Typ High Slew Rate . . . 9 V/μs Typ Peak-to-Peak Output Voltage Swing 32 V Typ, With VCC± = ±18 V and RL = 600 Ω Wide Supply-Voltage Range . . . ±3 V to ±20 V Common-Mode Rejection Ratio . . . 100 dB Ty

DUAL LOW-NOISE HIGH-DRIVE OPERATIONAL AMPLIFIER

文件：120 Kbytes Page：7 Pages

DUAL LOW-NOISE HIGH-DRIVE OPERATIONAL AMPLIFIER

文件：205.77 Kbytes Page：8 Pages

DUAL LOW-NOISE HIGH-DRIVE OPERATIONAL AMPLIFIER

文件：670.61 Kbytes Page：9 Pages

丝印代码：T4581；DUAL LOW-NOISE HIGH-DRIVE OPERATIONAL AMPLIFIER

Equivalent Input Noise Voltage 5 nV/√Hz Typ at 1 kHz Unity-Gain Bandwidth . . . 10 MHz Typ High Slew Rate . . . 9 V/μs Typ Peak-to-Peak Output Voltage Swing 32 V Typ, With VCC± = ±18 V and RL = 600 Ω Wide Supply-Voltage Range . . . ±3 V to ±20 V Common-Mode Rejection Ratio . . . 100 dB Ty

DUAL LOW-NOISE HIGH-DRIVE OPERATIONAL AMPLIFIER

文件：205.77 Kbytes Page：8 Pages

6.4 VOLT ZENER VOLTAGE 5

• 1N4565A THRU 1N4584A AVAILABLE IN JANHC AND JANKC PER MIL-PRF-19500/452 • ALL JUNCTIONS COMPLETELY PROTECTED WITH SILICON DIOXIDE • 6.4 VOLT ZENER VOLTAGE + 5 • ELECTRICALLY EQUIVALENT TO 1N4565 THRU 1N4584A • COMPATIBLE WITH ALL WIRE BONDING AND DIE ATTACH TECHNIQUES, WITH THE EXCEPTION OF

Sync Separator, 50 Slice, S-H, Filter

General Description The EL4581C extracts timing information from standard negative going video sync found in NTSC, PAL, and SECAM broadcast systems. It can also be used in non standard formats and with computer graphics systems at higher scan rates, by adjusting a single external resistor. When t

Sync Separator, 50 Slice, S-H, Filter

General Description The EL4581C extracts timing information from standard negative going video sync found in NTSC, PAL, and SECAM broadcast systems. It can also be used in non standard formats and with computer graphics systems at higher scan rates, by adjusting a single external resistor. When t

Preamplifier Power Amplifier for 3V Headphone Stereos

Overview The LA4581MB is an auto reverse-supported preamplifier + power amplifier IC that is intended for use in 3V headphone stereos. Features • Preamplifier muting and preamplifier output on/off can be implemented with one pin. This IC can easily be used to construct a set with a radio. • Th

Preamplifier Power Amplifier for 3V Headphone Stereos

Overview The LA4581MB is an auto reverse-supported preamplifier + power amplifier IC that is intended for use in 3V headphone stereos. Features • Preamplifier muting and preamplifier output on/off can be implemented with one pin. This IC can easily be used to construct a set with a radio. • Th