Hall Effect Sensor ICs

The SS1034 is a unipolar Hall-effect sensor IC fabricated from bipolar technology. The device integrates a voltage regulator, reverse battery protection diode, Hall sensor with dynamic offset cancellation system, temperature compensation circuitry, small signal amplifier, Schmitt trigger and an open \n●4.5V to 24V Operation\n●-40°C to 150°C Superior temperature operation\n●Bipolar technology\n●Low current consumption\n●Chopper-stabilized amplifier stage\n●Open drain output\n●Low sensitivity\n●Small Size-SOT23 3L or SIP 3L both RoHS compliant packages;

Unipolar Hall-Effect Digital Switch

文件：511.5 Kbytes Page：8 Pages

Unipolar Hall-Effect Digital Switch

文件：511.5 Kbytes Page：8 Pages

Unipolar Hall-Effect Digital Switch

文件：511.5 Kbytes Page：8 Pages

Unipolar Hall-Effect Digital Switch

文件：511.5 Kbytes Page：8 Pages

Unipolar Hall-Effect Digital Switch

文件：511.5 Kbytes Page：8 Pages

Unipolar Hall-Effect Digital Switch

文件：511.5 Kbytes Page：8 Pages

Unipolar Hall-Effect Digital Switch

文件：511.5 Kbytes Page：8 Pages

Receiving Mixer

Description The CXG1034TN is a receiving mixer MMIC. This IC is designed using the Sony’s GaAs J-FET process. Features • Low distortion Input IP3=+1.5 dBm (Typ.) • Low LO input power operation PLO=–15 dBm • RF, LO input matching circuit • Single 3 V power supply operation • 10-pin TSSOP pac

Voltage Regulator

General Description The HT10XX series is a set of three-terminal low power voltage regulators implemented in CMOS technology. They are available with several fixed output voltages ranging from 1.5V~7.0V. The ad vantage of CMOS technology is low voltage drop out and low quiescent current. Featu

Linear Building Block . Single Operational Amplifiers in SOT Packages

General Description The TC1034/TC1035 are single CMOS operational amplifiers for low power applications. They have a typical operating supply current of 6µA, which is constant over the supply voltage range of 1.8V to 5.5V. The Op Amp has a rail-to-rail input and output which allows operation at

Linear Building Block . Single Operational Amplifiers in SOT Packages

General Description The TC1034/TC1035 are single CMOS operational amplifiers for low power applications. They have a typical operating supply current of 6µA, which is constant over the supply voltage range of 1.8V to 5.5V. The Op Amp has a rail-to-rail input and output which allows operation at

PATENTED GOLD METALIZED SILICON GATE ENHANCEMENT MODE RF POWER VDMOS TRANSISTOR

文件：31.51 Kbytes Page：2 Pages