36 V, 600 mA Buck Converter

Features  Qualified for Automotive Applications  AEC-Q100 Qualified with the Following Results: . Device Temperature Grade 1: -40 °C to 125 °C  Ambient Operating Temperature Range . Device HBM ESD Classification Level H1C . Device CDM ESD Classification Level C4A  4 V to 36 V Input Rang

Compact 6 pin DIP/SMD package

Features  Compact 6 pin DIP/SMD package  Built in active discharge circuit for fast turn-off  Fast Turn-On  6V Gate Drive Voltage  High Input-to-Output Isolation (up to 5kVRMS)  Long Life / High Reliability  RoHS / Pb-Free / REACH Compliant Applications  Isolated means to drive

开关调节器

Built in active discharge circuit for fast turn-off

文件：223.15 Kbytes Page：7 Pages

SOFTWARE WRITE PROTECT I2C BUS 2KBIT EEPROM

General Description The AK6003A is a 2048-bit serial CMOS E2PROM divided into 256 registers of 8 bits each. The AK6003A can operate full function under wide operating voltage range from 1.8V to 5.5V. The charge up circuit is integrated for high voltage generation that is used for write operation.

SCRs 1-70 AMPS NON-SENSITIVE GATE

Features ● Electrically Isolated Packages ● High Voltage Capability - 30 - 600 Volts ● High Surge Capability - up to 950 Amps ● Glass Passivated Chip

HIGH FREQUENCY SECONDARY RECTIFIER

DESCRIPTION Dual rectifiers suited for Switch Mode Power Supplyand high frequencyDC to DC converters. Packaged either in ISOTOP or in TO-247, this device is intended for use in low voltage, high frequency inverters, free wheeling operation, welding equipmentsand telecom power supplies. FEATURES

HIGH FREQUENCY SECONDARY RECTIFIER

DESCRIPTION Dual rectifiers suited for Switch Mode Power Supplyand high frequencyDC to DC converters. Packaged either in ISOTOP or in TO-247, this device is intended for use in low voltage, high frequency inverters, free wheeling operation, welding equipmentsand telecom power supplies. FEATURES

HIGH FREQUENCY SECONDARY RECTIFIER

DESCRIPTION Dual rectifiers suited for Switch Mode Power Supplyand high frequencyDC to DC converters. Packaged either in ISOTOP or in TO-247, this device is intended for use in low voltage, high frequency inverters, free wheeling operation, welding equipmentsand telecom power supplies. FEATURES