FAST RECOVERY SINGLE PHASE BRIDGE RECTIFIER

10 amp recitifier assembly SSDI introduces a new and complete series of fast recovery bridge rectifier assemblies. Designed in cast aluminum cases to provide maximum thermal conductivity an simple installation. * AVERAGE OUTPUT CURRETN 10 AMPS * PIV 50 TO 1000 VOLTS * 150 NSEC. MAXIMUM RECOVER

10 A, 100 V Fast Recovery Single Phase Bridge Rectifier

• Average Output Current 10 Amps\n• PIV 100 Volts\n• Reverse Recovery Time 150 ns Max\n• Max Thermal Resistance 5.0°C/Watt\n• Hermetically Sealed Diode Cells\n• Turret Terminal\n• Aluminum Case\n• Available in Standard, Ultrafast, and Hyperfast Versions - Consult Factory\n• TX and TXV Screening Avai;

10 A, 100 V Ultrafast Recovery Single Phase Bridge Rectifier

• Average Output Current 10 Amps\n• PIV 50 to 1000 Volts\n• Reverse Recovery Time 60-80 ns Max\n• Max Thermal Resistance 5.0oC/Watt\n• Hermetically Sealed Diode Cells\n• Turret Terminal\n• Aluminum Case\n• Available in Standard, Ultra Fast, and Hyper Fast versions - Consult Factory\n• TX and TXV Scr;

10 AMPS 50 ??1000 VOLTS ULTRA FAST RECOVERY SINGLE PHASE BRIDGE RECTIFIER

10 AMPS 50 ─1000 VOLTS ULTRA FAST RECOVERY SINGLE PHASE BRIDGE RECTIFIER FEATURES: • Average Output Current 10 Amps • PIV 50 to 1000 Volts • Reverse Recovery Time 60-80 ns Max • Max Thermal Resistance 5.0oC/Watt • Hermetically Sealed Diode Cells • Turret Terminal • Aluminum Case •

GaAs-IR-Lumineszenzdioden-Zeilen GaAs Infrared Emitter Arrays

Features ● GaAs infrared emitting diode, fabricated in a liquid phase epitaxy process ● High reliability ● Same package as BPX 80 series Applications ● Miniature photointerrupters ● Punched tape-readers ● Industrial electronics ● For control and drive circuits

Silicon NPN Transistor High Gain Darlington Power Amp, Switch

Features: • Forward Current Transfer Ratio: hFE = 90,000 min. • Free–Air Power Dissipation: 1.33W @ TA = +50°C • Hard Solder Mountdown Applications: • Driver • Regulator • Audio Output • Relay Substitute • Touch Switch • Oscillator • IC Driver • Servo Amplifie

TRISILTM

DESCRIPTION The SMTPBxx series has been designedto protect telecommunication equipment against lightning and transient induced by AC power lines. FEATURES BIDIRECTIONAL CROWBAR PROTECTION. BREAKDOWNVOLTAGE RANGE: From 62 V To 270 V. HOLDING CURRENT: IH= 150 mA min REPETITIVE PE

Enhanced, Energy Efficient, Low Power Off-line Switcher

Description TinySwitch-II integrates a 700 V power MOSFET, oscillator, high voltage switched current source, current limit and thermal shutdown circuitry onto a monolithic device. The start-up and operating power are derived directly from the voltage on the DRAIN pin, eliminating the need for a b

Enhanced, Energy Efficient, Low Power Off-line Switcher

Description TinySwitch-II integrates a 700 V power MOSFET, oscillator, high voltage switched current source, current limit and thermal shutdown circuitry onto a monolithic device. The start-up and operating power are derived directly from the voltage on the DRAIN pin, eliminating the need for a b