USB-C Switch with CC Logic Controller and USB 3.1 Gen 2 Retimer

The PS8803 addresses high-speed signal switching and signal integrity requirements for the implementation of a USB Type-C (or USB-C) connector on a USB host or device that supports USB 3.1 transport data rates up to 10Gbit/sec (Gen 2). To compensate for PCB signal loss and other signal distortion, t Flexible USB Type-C switching support for USB 3.1 Gen1 and Gen2\nFast Low Frequency Periodic Signaling (LFPS) enter/exit time\nUSB 3.1 Gen2 10Gbps retiming\nSupports full USB 3.1power management with automatic power saving\nCrystalFree operation, no external crystal or external reference clock neede;

Voltage Detector

Voltage Detector

Octal 8-Bit TrimDAC with Power Shutdown

GENERAL DESCRIPTION The AD8801/AD8803 provides eight digitally controlled dc voltage outputs. This potentiometer divider TrimDAC® allows replacement of the mechanical trimmer function in new designs. The AD8801/AD8803 is ideal for dc voltage adjustment applications. FEATURES Low Cost

Octal 8-Bit TrimDAC with Power Shutdown

GENERAL DESCRIPTION The AD8801/AD8803 provides eight digitally controlled dc voltage outputs. This potentiometer divider TrimDAC® allows replacement of the mechanical trimmer function in new designs. The AD8801/AD8803 is ideal for dc voltage adjustment applications. FEATURES Low Cost

LIGHT EMITTING DIODE DRIVER

DESCRIPTION The block Diagram of the SA8803 is shown in Fig. 1. A control word is clocked into the device via the DATA pin with a local clock provided to pin CLK. The control word comprises a 3-bit chip address, a 5-bit LED address and a Status (on/off) bit. Provided that the Chip Adress matches

10/15 CH PLL

文件：109.97 Kbytes Page：9 Pages

10/15 CH PLL

文件：109.97 Kbytes Page：9 Pages