1 Watt RF Load with Chain Up to 50 GHz with 2.4mm Male Passivated Stainless Steel

1 Watt RF Load with Chain Up to 50 GHz with 2.4mm Male Passivated Stainless Steel\n\nPE6179 1 Watts RF load (also known as termination or dummy load) has a 2.4mm connector that is male. This Pasternack 1 watt 2.4mm male load / termination is rated for a maximum frequency of 50 GHz. Our 2.4mm male te Key Specifications (Click on Data Sheet Above for Additional Details).\n• Connector Series2.4mm\n• Minimum FrequencyDC\n• Impedance50 Ohm\n• Maximum Power1 Watt\n;

50 Ohm 1 Watt Precision 2.4mm Male RF Load with Chain Up To 50 GHz

文件：356.04 Kbytes Page：3 Pages

1 Watt RF Load with Chain Up to 50 GHz

文件：443.43 Kbytes Page：4 Pages

1 Watt RF Load with Chain Up to 50 GHz

文件：443.43 Kbytes Page：4 Pages

AM Receiver IC

DESCRIPTION The MAS6179 AM-Receiver chip is a highly sensitive, simple to use AM receiver specially intended to receive time signals in the frequency range from 40 kHz to 100 kHz. Only a few external components are required for time signal receiving. The circuit has preamplifier, wide range aut

Diplexer, 5-85/108-1002MHz

文件：49.79 Kbytes Page：2 Pages

Single-Phase Full-Wave Motor Driver for Fan Motor

文件：260.22 Kbytes Page：11 Pages