Power amplifier controller for GSM and PCN systems

FEATURES • CMOS low-voltage, low-power • Can be used in burst mode with power-down • 3-wire serial bus interface with the bus available in Power-down mode • On-chip ramp generator for 256 different power levels with two dynamic ranges • Two programmable regulator start conditions (VKICK and V

Power amplifier controller for GSM and PCN systems

Push-Pull FET Driver with Integrated Oscillator and Programmable Clock Output

General Description The MAX5077 is a +4.5V to +15V push-pull, current-fed topology driver subsystem with an integrated oscillator used in telecom module power supplies. The device drives two MOSFETs connected to a center-tapped transformer primary providing secondary-side, isolated, negative or p

Push-Pull FET Driver with Integrated Oscillator and Programmable Clock Output

General Description The MAX5077 is a +4.5V to +15V push-pull, current-fed topology driver subsystem with an integrated oscillator used in telecom module power supplies. The device drives two MOSFETs connected to a center-tapped transformer primary providing secondary-side, isolated, negative or p

LOW PROFILE T-1 SOLID STATE LAMPS

DESCRIPTION These solid state indicators offer a variety of color selection. The High Efficiency Red, Green and Yellow devices are made with a gallium arsenide phosphide LED on gallium phosphide substrate. All are encapsulated in epoxy packages. Their low profile, small size (approximately T-1 si

LOW PROFILE T-1 SOLID STATE LAMPS

文件：256 Kbytes Page：3 Pages