丝印代码：O4140A；OPAx140 High-Precision, Low-Noise, Rail-to-Rail Output, 11-MHz, JFET Op Amps

1 Features • Very-low offset drift: 1 μV/°C maximum • Very-low offset: 120 μV • Low input bias current: 10 pA maximum • Very-low 1/f noise: 250 nVPP, 0.1 Hz to 10 Hz • Low noise: 5.1 nV/√Hz • Slew rate: 20 V/μs • Low supply current: 2 mA maximum • Input voltage range includes V– supply •

丝印代码：O4140A；OPAx140 High-Precision, Low-Noise, Rail-to-Rail Output, 11-MHz, JFET Op Amps

1 Features • Very-low offset drift: 1 μV/°C maximum • Very-low offset: 120 μV • Low input bias current: 10 pA maximum • Very-low 1/f noise: 250 nVPP, 0.1 Hz to 10 Hz • Low noise: 5.1 nV/√Hz • Slew rate: 20 V/μs • Low supply current: 2 mA maximum • Input voltage range includes V– supply •

High-Precision, Low-Noise, Rail-to-Rail Output 11MHz JFET Op Amp

文件：807.26 Kbytes Page：25 Pages

11-MHz JFET Op Amp

文件：1.75261 Mbytes Page：44 Pages

丝印代码：O4140A；OPAx140 High-Precision, Low-Noise, Rail-to-Rail Output, 11-MHz, JFET Op Amp

文件：2.85372 Mbytes Page：48 Pages

丝印代码：O4140A；OPAx140 High-Precision, Low-Noise, Rail-to-Rail Output, 11-MHz, JFET Op Amps

1 Features • Very-low offset drift: 1 μV/°C maximum • Very-low offset: 120 μV • Low input bias current: 10 pA maximum • Very-low 1/f noise: 250 nVPP, 0.1 Hz to 10 Hz • Low noise: 5.1 nV/√Hz • Slew rate: 20 V/μs • Low supply current: 2 mA maximum • Input voltage range includes V– supply •

0.5W AF Power Amplifier

2-CHANNEL AF POWER AMP. FOR TAPE RECORDER, RADIO 0.5W TYP AF POWER AMP. FOR RADIO OR TAPE RECORDER 0.6 TO 0.9W AF POWER AMP.

Silicon planar type

Silicon planar type For stabilization of power supply ■ Features • High reliability, achieved by the DHD structure • Allowing to insert to a 5 mm pitch hole • Finely divided zener-voltage rank • Sharp rising performance • Wide voltage range: VZ = 2.0 V to 39 V

40 V low VCEsat NPN transistor

DESCRIPTION NPN low VCEsat transistor in a SOT54 plastic package. PNP complement: PBSS5140S. FEATURES • High power dissipation (830 mW) • Ultra low collector-emitter saturation voltage • 1 A continuous current • High current switching • Improved device reliability due to reduced heat gener

Low Power Two-Wire Ground Fault Interrupter Controller

Description The RV4140A is a low power controller for AC outlet appliance leakage circuit interrupters. These devices detect hazardous current paths to ground such as an appliance falling into water. The interrupter then open circuits the line before a harmful or lethal shock occurs. Features •

Photo Modules for PCM Remote Control Systems

DESCRIPTION These products are miniaturized receivers for infrared remote control systems. A PIN diode and a preamplifier are assembled on a lead frame, the epoxy package contains an IR filter. The demodulated output signal can be directly connected to a microprocessor for decoding. FEATURES •