SOT23, Single-Supply, Low-Noise, Low-Distortion, Rail-to-Rail Op Amps

General Description The MAX4249–MAX4257 low-noise, low-distortion operational amplifiers offer Rail-to-ail®outputs and single supply operation down to 2.4V. They draw only 400µA of quiescent supply current per amplifier while featuring ultra-low distortion (0.0002 THD), as well as low input vol

UCSP, Single-Supply, Low-Noise, Low-Distortion, Rail-to-Rail Op Amps

Features ● Available in Space-Saving UCSP, SOT23, and μMAX® Packages ● Low Distortion: 0.0002% THD (1kΩ load) ● 400μA Quiescent Supply Current per Amplifier ● Single-Supply Operation from 2.4V to 5.5V ● Input Common-Mode Voltage Range Includes Ground ● Outputs Swing Within 8mV of Rails

UCSP封装、单电源、低噪声、低失真、满摆幅运算放大器

UCSP, Single-Supply, Low-Noise, Low-Distortion, Rail-to-Rail Op Amps

文件：1.37358 Mbytes Page：21 Pages

UCSP, Single-Supply, Low-Noise, Low-Distortion, Rail-to-Rail Op Amps

文件：738.28 Kbytes Page：16 Pages

UCSP, Single-Supply, Low-Noise, Low-Distortion, Rail-to-Rail Op Amps

Features ● Available in Space-Saving UCSP, SOT23, and μMAX® Packages ● Low Distortion: 0.0002% THD (1kΩ load) ● 400μA Quiescent Supply Current per Amplifier ● Single-Supply Operation from 2.4V to 5.5V ● Input Common-Mode Voltage Range Includes Ground ● Outputs Swing Within 8mV of Rails

UCSP, Single-Supply, Low-Noise, Low-Distortion, Rail-to-Rail Op Amps

Features ● Available in Space-Saving UCSP, SOT23, and μMAX® Packages ● Low Distortion: 0.0002% THD (1kΩ load) ● 400μA Quiescent Supply Current per Amplifier ● Single-Supply Operation from 2.4V to 5.5V ● Input Common-Mode Voltage Range Includes Ground ● Outputs Swing Within 8mV of Rails

UCSP, Single-Supply, Low-Noise, Low-Distortion, Rail-to-Rail Op Amps

文件：738.28 Kbytes Page：16 Pages

UCSP, Single-Supply, Low-Noise, Low-Distortion, Rail-to-Rail Op Amps

文件：738.28 Kbytes Page：16 Pages

75 廓 SPDT CATV UltraCMOS??Switch DC - 3.0 GHz

Product Description The PE4256 is an UltraCMOS™ Switch designed for CATV applications, covering a broad frequency range from 5 MHz up to 3 GHz. This single-supply SPDT switch integrates a two-pin CMOS control interface. It also provides low insertion loss with extremely low bias requirements whil

256Kbit and 128Kbit Serial I2C Bus EEPROM With Three Chip Enable Lines

Description The M24256 is a 256-Kbit I2C-compatible EEPROM (Electrically Erasable PROgrammable Memory) organized as 32 K × 8 bits. Features • Compatible with all I2C bus modes: – 1 MHz – 400 kHz – 100 kHz • Memory array: – 256 Kbit (32 Kbyte) of EEPROM – Page size: 6

Drive Fasteners

文件：93.97 Kbytes Page：1 Pages

Brass Heat-Set Inserts for Plastic - M3 x 3mm - 50 pack

文件：939.33 Kbytes Page：2 Pages

256-Kbit serial I짼C bus EEPROM

文件：410.75 Kbytes Page：41 Pages