Dual 10-Bit, 20Msps, 3V, Low-Power ADC with Internal Reference and Parallel Outputs

General Description The MAX1184 is a 3V, dual 10-bit analog-to-digital converter (ADC) featuring fully-differential wideband track-and-hold (T/H) inputs, driving two pipelined, 9-stage ADCs. The MAX1184 is optimized for low-power, high-dynamic performance applications in imaging, instrumentation,

Single-Ended or Fully Differential Signal Input Configuration

文件：497.32 Kbytes Page：9 Pages

双路、10位、20Msps、+3V、低功耗ADC，内置电压基准及并行输出

Dual 10-Bit, 20Msps, 3V, Low-Power ADC with Internal Reference and Parallel Outputs

General Description The MAX1184 is a 3V, dual 10-bit analog-to-digital converter (ADC) featuring fully-differential wideband track-and-hold (T/H) inputs, driving two pipelined, 9-stage ADCs. The MAX1184 is optimized for low-power, high-dynamic performance applications in imaging, instrumentation,

Single-Ended or Fully Differential Signal Input Configuration

文件：497.32 Kbytes Page：9 Pages

封装/外壳：48-TQFP 裸露焊盘 包装：管件 描述：IC ADC 10BIT PIPELINED 48TQFP 集成电路（IC） 模数转换器（ADC）

封装/外壳：48-TQFP 裸露焊盘 包装：托盘 描述：IC ADC 10BIT PIPELINED 48TQFP 集成电路（IC） 模数转换器（ADC）

Standard Two-Wire Field-Programmable Chopper-Stabilized Unipolar Hall-Effect Switches

The A1184 device is a standard, two-wire, unipolar, Hall effect switches. The operate point, BOP, can be field-programmed, after final packaging of the sensor and placement into the application. This advanced feature allows the optimization of the sensor switching performance, by effectively accou

Standard Two-Wire Field-Programmable Chopper-Stabilized Unipolar Hall-Effect Switches

Features and Benefits ▪ Chopper stabilization ▫ Low switchpoint drift over operating temperature range ▫ Low sensitivity to stress ▪ Field programmable for optimized switchpoints ▪ On-chip protection ▫ Supply transient protection ▫ Reverse-battery protection ▫ On-board voltage regulator

Two-Wire, Programmable, Chopper-Stabilized, Unipolar Hall-Effect Switch

Description The A1180, A1181, A1182, and A1183 devices are sensitive, two-wire, unipolar, Hall effect switches. The operate point, BOP, can be field-programmed, after final packaging of the sensor and placement into the application. This advanced feature allows the optimization of the sensor sw

Timing Belt GT2 Profile - 2mm pitch - 6mm wide 1164mm long

文件：115.88 Kbytes Page：2 Pages

Original Strain Relief Bushings

文件：112.65 Kbytes Page：1 Pages