Low Quiescent Current Ideal Diode Controller

DESCRIPTION The LTC®4372/LTC4373 are positive high voltage ideal diode controllers that drive an external N-channel MOSFET to replace a Schottky diode. They control the forward voltage drop across the MOSFET to ensure current delivery or current transfer from one path to the other even at light l

Floating, High-Voltage Active Rectifier Controller

DESCRIPTION The LT4322 is a floating active rectifier controller that drives an external N-Channel MOSFET to replace a rectifier diode. It is designed primarily for AC applications and operates with input supply frequencies ranging from DC to 100kHz. On each cycle of the input AC waveform, a

28V, 2A Ideal Diode and Load Switch

FEATURES  Internal 200mΩ Power Path  Wide Operating Voltage Range: 1.9V to 28V  Reverse Current Protection  Load Switch Capability  Low 10μA Quiescent Current  Fast 3μs Response to Load Steps  Low 500nA Off State Current  Smooth Switchover in Diode-OR Applications  Integrated The

双通道、低电压理想二极管控制器

18V, 12A Ideal Diode

文件：1.1423 Mbytes Page：14 Pages

40V, 7A Ideal Diode

文件：1.05872 Mbytes Page：14 Pages

Dual 12V Ideal Diode-OR and Single Hot Swap Controller with Current Monitor

文件：496.29 Kbytes Page：22 Pages

Dual Ideal Diode-OR and Single Hot Swap Controller with Current Monitor

文件：563.45 Kbytes Page：24 Pages

封装/外壳：16-WFDFN 裸露焊盘 包装：管件 描述：IC OR CTRLR N-CH 2CH 16DFN 集成电路（IC） OR 控制器，理想二极管

封装/外壳：16-TFSOP（0.118"，3.00mm 宽） 包装：管件 描述：IC OR CTRLR LOAD SHARE 16MSOP 集成电路（IC） OR 控制器，理想二极管

96kHz 24BIT DAC WITH DIT

GENERAL DESCRIPTION The AK4353 is a stereo CMOS D/A Converter and Digital Audio Interface Transmitter. The DAC signal outputs are single-ended and are analog filtered to remove out of band noise. Therefore no external filters are required. The AK4353 can operate at the power supply from 2.7V to 5

96kHz 24BIT DAC WITH DIT

GENERAL DESCRIPTION The AK4353 is a stereo CMOS D/A Converter and Digital Audio Interface Transmitter. The DAC signal outputs are single-ended and are analog filtered to remove out of band noise. Therefore no external filters are required. The AK4353 can operate at the power supply from 2.7V to 5

EVALUATION BOARD REV.A FOR AK4353

GENERAL DESCRIPTION The AK4353 is a stereo CMOS D/A Converter and Digital Audio Interface Transmitter. The DAC signal outputs are single-ended and are analog filtered to remove out of band noise. Therefore no external filters are required. The AK4353 can operate at the power supply from 2.7V to 5

Panel Mount Lenses for T-1 (3mm) LEDs

文件：79.98 Kbytes Page：1 Pages

Adafruit Perma Proto 40 Pin Raspberry Pi Half Size PCB Kit - with 2x20 Header

文件：2.08775 Mbytes Page：3 Pages