LOW POWER DUAL VOLTAGE COMPARATORS

DESCRIPTION These devices consist of two independent low voltage comparators designed specifically to operate from a single supply over a wide range of voltages. Operation from split power supplies is also possible. ■ WIDE SINGLE SUPPLY VOLTAGE RANGE OR DUAL SUPPLIES : +2V TO +36V OR ±1V

SILICON MONNOLITHIC INTEGRATED CIRCUIT

General Description LM393xxx, LM2903xx, LM339xx, and LM2901xx monolithic ICs integrate two or four independent comparator circuits on a single chip and feature high gain, low power consumption, and an operating voltage range from 2V to 36V (single power supply). Features ■ Operable with a Singl

SIGNATURE SERIES Comparators

文件：422.59 Kbytes Page：18 Pages

SIGNATURE SERIES Comparators

文件：866.44 Kbytes Page：38 Pages

Standard Open-Collector Comparator

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS The LM393 series are dual independent precision voltage comparators capable of single or split supply operation. These devices are designed to permit a common mode range–to–ground level with single supply operation. Input offset voltage specifications

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS The LM393 series are dual independent precision voltage comparators capable of single or split supply operation. These devices are designed to permit a common mode range–to–ground level with single supply operation. Input offset voltage specifications

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS

SINGLE SUPPLY, LOW POWER DUAL COMPARATORS The LM393 series are dual independent precision voltage comparators capable of single or split supply operation. These devices are designed to permit a common mode range–to–ground level with single supply operation. Input offset voltage specifications

High Voltage Transistors(NPN)

High Voltage Transistors NPN Silicon

BROADBAND PUSH-PULL RF POWER TRANSISTOR NPN SILICON

The RF Line NPN Silicon Push-Pull RF Power Transistor . . . designed primarily for wideband large–signal output and driver amplifier stages in the 30 to 500 MHz frequency range. • Specified 28 Volt, 500 MHz Characteristics — Output Power = 100 W Typical Gain = 9.5 dB (Class A