High Voltage, Solid State Relay-MOSFET Output

Description The KAQV214 series is robust, ideal for telecom and ground fault applications. It is a SPST normally open switch (1 Form A) that replaces electromechanical relays in many applications. It is constructed using a GaAlAs LED for actuation control and an integrated monolithic die for the

6PIN 400V N.O TYPE SOLID STATE RELAY-MOSFET OUTPUT

Description The KAQV214 series is robust, ideal for telecom and ground fault applications. It is a SPST normally open switch (1 Form A) that replaces electromechanical relays in many applications. It is constructed using a GaAlAs LED for actuation control and an integrated monolithic die for the

SOLID STATE RELAY - MOSFET OUTPUT

PRODUCT SPECIFICATION

文件：170.59 Kbytes Page：7 Pages

6PIN 400V N.O TYPE SOLID STATE RELAY-MOSFET OUTPUT

文件：272.67 Kbytes Page：12 Pages

6PIN 400V N.O TYPE SOLID STATE RELAY-MOSFET OUTPUT

文件：272.67 Kbytes Page：12 Pages

CCD Video Camera Signal Processor ICs

■ Overview The AN2145NFHP is a CCD video camera signal processor IC for 510H CCD. It incorporates full chroma signal LPFs and horizontal aperture correction circuits. Because carrier-balance is rationalized and ajustment-free, adjustments and necessary external components are reduced half in numb

Amlifier Transistors (PNP)

Amplifier Transistors PNP Silicon

LOW DROP POWER SCHOTTKY RECTIFIER

Description Schottky rectifiers designed for high frequency miniature switched mode power supplies such as adaptors and on board DC/DC converters. Packaged in SMA or SMB, the STPS1L30 is ideal for use in parallel with MOSFETs in synchronous rectification. Features • Very low forward voltage dr

Silicon NPN Transistor Darlington Driver

Description: The NTE214 is a silicon NPN Darlington transistor in a TO3P type package. Typical applications include motor drivers, printer hammer drivers, relay drivers, regulated DC power supply controllers. Features: • High DC Current Gain • Large Current Capacity and Wide ASO •

TRISILTM

DESCRIPTION The SMTPBxx series has been designedto protect telecommunication equipment against lightning and transient induced by AC power lines. FEATURES BIDIRECTIONAL CROWBAR PROTECTION. BREAKDOWNVOLTAGE RANGE: From 62 V To 270 V. HOLDING CURRENT: IH= 150 mA min REPETITIVE PE