Dual Path RF Switch with LNA and DVGA 2.3GHz to 2.7GHz

Features  Gain at 2.6GHz • 34dB typical in High Gain Mode • 28dB typical in Low Gain Mode  1.5dB NF at 2.6GHz  +23dBm OIP3 at 2.6GHz  OP1dB at 2.6GHz • +15dBm in High Gain Mode • +14dBm in Low Gain Mode  50Ω single-ended input / output amplifier impedances  IDD = 130mA  Independe

Dual Path RF Switch / LNA 2300MHz to 2700MHz

The F0452B is an integrated dual-path RF front-end consisting of an RF switch and two gain stages with 6dB gain control used in the analog front-end receiver of an Active Antenna System (AAS). The F0452B supports frequencies from 2300MHz to 2700MHz.\n\nThe F0452B provides 34dB gain with +23dBm OIP3, Gain at 2600MHz34dB typical in High Gain Mode\n28dB typical in Low Gain Mode\n;

Dual Path RF Switch with LNA and DVGA 2.3GHz to 2.7GHz

文件：3.48998 Mbytes Page：29 Pages

Dual Path RF Switch with LNA and DVGA 2.3GHz to 2.7GHz

Features  Gain at 2.6GHz • 34dB typical in High Gain Mode • 28dB typical in Low Gain Mode  1.5dB NF at 2.6GHz  +23dBm OIP3 at 2.6GHz  OP1dB at 2.6GHz • +15dBm in High Gain Mode • +14dBm in Low Gain Mode  50Ω single-ended input / output amplifier impedances  IDD = 130mA  Independe

Dual Path RF Switch with LNA and DVGA 2.3GHz to 2.7GHz

Features  Gain at 2.6GHz • 34dB typical in High Gain Mode • 28dB typical in Low Gain Mode  1.5dB NF at 2.6GHz  +23dBm OIP3 at 2.6GHz  OP1dB at 2.6GHz • +15dBm in High Gain Mode • +14dBm in Low Gain Mode  50Ω single-ended input / output amplifier impedances  IDD = 130mA  Independe

Dual Path RF Switch with LNA and DVGA 2.3GHz to 2.7GHz

Features  Gain at 2.6GHz • 34dB typical in High Gain Mode • 28dB typical in Low Gain Mode  1.5dB NF at 2.6GHz  +23dBm OIP3 at 2.6GHz  OP1dB at 2.6GHz • +15dBm in High Gain Mode • +14dBm in Low Gain Mode  50Ω single-ended input / output amplifier impedances  IDD = 130mA  Independe

Dual Path RF Switch with LNA and DVGA 2.3GHz to 2.7GHz

Features  Gain at 2.6GHz • 34dB typical in High Gain Mode • 28dB typical in Low Gain Mode  1.5dB NF at 2.6GHz  +23dBm OIP3 at 2.6GHz  OP1dB at 2.6GHz • +15dBm in High Gain Mode • +14dBm in Low Gain Mode  50Ω single-ended input / output amplifier impedances  IDD = 130mA  Independe

Dual Path RF Switch with LNA and DVGA 2.3GHz to 2.7GHz

文件：3.48998 Mbytes Page：29 Pages

Dual Path RF Switch with LNA and DVGA 2.3GHz to 2.7GHz

文件：3.48998 Mbytes Page：29 Pages

封装/外壳：32-WFLGA 裸露焊盘 包装：卷带（TR） 描述：LGA 5.00X5.00X0.80 MM, 0.50MM PI RF/IF，射频/中频和 RFID 射频放大器

封装/外壳：32-WFLGA 裸露焊盘 包装：卷带（TR） 描述：LGA 5.00X5.00X0.80 MM, 0.50MM PI RF/IF，射频/中频和 RFID 射频放大器

Dual Path RF Switch with LNA and DVGA 2.3GHz to 2.7GHz

文件：3.48998 Mbytes Page：29 Pages

High Speed Transistor Optocouplers

Description The HCPL05XX, and HCPL04XX optocouplers consist of an AlGaAs LED optically coupled to a high speed photodetector transistor housed in a compact 8-pin small outline package. A separate connection for the bias of the photodiode improves the speed by several orders of magnitude over con

Single Channel, High Speed Optocouplers

Description These diode-transistor optocouplers use an insulating layer between a LED and an integrated photodetector to provide electrical insulation between input and output. Separate connections for the photodiode bias and output-transistor collector increase the speed up to a hundred times th

Quad Port Bypass Circuit with CDR for Fibre Channel Arbitrated Loops

Description The HDMP-0452 is a Quad Port Bypass Circuit (PBC) with a Clock and Data Recovery (CDR) circuit included. This device minimizes part count, cost and jitter accumulation while repeating incoming signals. Port Bypass Circuits are used in hard disk arrays constructed in Fibre Channel Arbi

Silicon N Channel Power MOS FET Power Switching

文件：87.31 Kbytes Page：7 Pages

SAW Filter 861MHz SMD 3.8횞3.8mm

文件：1.08123 Mbytes Page：6 Pages