30V Input Standoff, 1A Fully Integrated Linear Charger for 1 Cell Li-ion Battery

ETA4140 is a single cell, fully integrated constant current (CC)/constant voltage (CV) Li-ion battery charger. Its compact package with minimum external components requirement makes the ETA4140 ideal for portable applications. No external sense resistor or blocking diode is necessary for the ETA4140 • 30V Input Standoff Voltage\n\n• 4.2V Charge Termination Voltage\n\n• Charge Current Programmable, Up to 1A\n\n• Pin Selectable USB 100mA or 500mA Maximum Input Current Limit\n\n• Programmable Termination Current and Pre-charge Current Threshold\n\n• Operation over JEITA Range via Battery NTC\n\n• ;

0.5W AF Power Amplifier

2-CHANNEL AF POWER AMP. FOR TAPE RECORDER, RADIO 0.5W TYP AF POWER AMP. FOR RADIO OR TAPE RECORDER 0.6 TO 0.9W AF POWER AMP.

Silicon planar type

Silicon planar type For stabilization of power supply ■ Features • High reliability, achieved by the DHD structure • Allowing to insert to a 5 mm pitch hole • Finely divided zener-voltage rank • Sharp rising performance • Wide voltage range: VZ = 2.0 V to 39 V

40 V low VCEsat NPN transistor

DESCRIPTION NPN low VCEsat transistor in a SOT54 plastic package. PNP complement: PBSS5140S. FEATURES • High power dissipation (830 mW) • Ultra low collector-emitter saturation voltage • 1 A continuous current • High current switching • Improved device reliability due to reduced heat gener

Low Power Two-Wire Ground Fault Interrupter Controller

Description The RV4140A is a low power controller for AC outlet appliance leakage circuit interrupters. These devices detect hazardous current paths to ground such as an appliance falling into water. The interrupter then open circuits the line before a harmful or lethal shock occurs. Features •

Photo Modules for PCM Remote Control Systems

DESCRIPTION These products are miniaturized receivers for infrared remote control systems. A PIN diode and a preamplifier are assembled on a lead frame, the epoxy package contains an IR filter. The demodulated output signal can be directly connected to a microprocessor for decoding. FEATURES •