Preservo amplifier for CD players

The BA6386K is a preservo amplifier for CD players. By using this paired with a ROHM DSP, a servo and main signal system can be configured with few external components and low power consumption. Features 1) Internal RF AGC circuits. 2) Internal APC circuit. 3) Internal auto asymmetry circuit.

Photosensor amplifier

Current-to-voltage conversion amplifier for amplifying weak photocurrent with low noise C2719 is a current-to-voltage conversion amplifier used to amplify weak photocurrent from a photodiode with very low noise. Three ranges of photocurrent detection sensitivity level (H, M, L) are selectable

HIGH-VOLTAGE HIGH AND LOW SIDE DRIVER

DESCRIPTION The L6386 is an high-voltage device, manufactured with the BCD ”OFF-LINE” technology. It has a Driver structure that enables to drive independent referenced Channel Power MOS or IGBT. The Upper (Floating) Section is enabled to work with voltage Rail up to 600V. The Logic Inputs are CM

SC70, Single/Dual Low-Voltage, Low-Power 關P Reset Circuits

General Description The MAX6381–MAX6390 microprocessor (µP) supervisory circuits monitor power-supply voltages from +1.8V to +5.0V while consuming only 3µA of supply current at +1.8V. Whenever VCC falls below the factory-set reset thresholds, the reset output asserts and remains asserted for a

50-4000 MHz Silicon Germanium Cascadable Gain Block

Product Description Sirenza Microdevices’ SGC-6386Z is a high performance SiGe HBT MMIC amplifier utilizing a Darlington configuration with an active bias network. The active bias network provides stable current over temperature and process Beta variations. Designed to run directly from a 5V supp