High-Speed CMOS Logic Quad 2-Input Multiplexers

Features • Common Select Inputs • Separate Enable Inputs • Buffered inputs and Outputs • Fanout (Over Temperature Range) - Standard Outputs . . . . . . . . . . . . . . . 10 LSTTL Loads - Bus Driver Outputs . . . . . . . . . . . . . 15 LSTTL Loads • Wide Operating Temperature Range . . . -55

High-Speed CMOS Logic Quad 2-Input Multiplexers

Features • Common Select Inputs • Separate Enable Inputs • Buffered inputs and Outputs • Fanout (Over Temperature Range) - Standard Outputs . . . . . . . . . . . . . . . 10 LSTTL Loads - Bus Driver Outputs . . . . . . . . . . . . . 15 LSTTL Loads • Wide Operating Temperature Range . . . -55

封装/外壳：16-SOIC（0.154"，3.90mm 宽） 包装：卷带（TR）剪切带（CT）Digi-Reel® 得捷定制卷带 描述：IC MULTIPLEXER 4 X 2:1 16SOIC 集成电路（IC） 信号开关，多路复用器，解码器

High-Speed CMOS Logic Quad 2-Input Multiplexers

文件：457.97 Kbytes Page：16 Pages

High-Speed CMOS Logic Quad 2-Input Multiplexers

文件：462.83 Kbytes Page：15 Pages

High-Speed CMOS Logic Quad 2-Input Multiplexers

文件：275.66 Kbytes Page：13 Pages

High-Speed CMOS Logic Quad 2-Input Multiplexers

文件：462.83 Kbytes Page：15 Pages

High-Speed CMOS Logic Quad 2-Input Multiplexers

文件：462.83 Kbytes Page：15 Pages

Quad 2-input multiplexer

GENERAL DESCRIPTION The 74HC/HCT157 are high-speed Si-gate CMOS devices and are pin compatible with low power Schottky TTL (LSTTL). They are specified in compliance with JEDEC standard no. 7A. FEATURES • Non-inverting data path • Output capability: standard • ICC category: MSI

Quad 2?묲nput Data Selectors / Multiplexers High?뭁erformance Silicon?묰ate CMOS

The 74HCT157 is identical in pinout to the LS157. The device inputs are compatible with standard CMOS outputs; with pullup resistors, they are compatible with LSTTL outputs. This device routes 2 nibbles (A or B) to a single port (Y) as determined by the Select input. The data is presented at the

Quad 2-input multiplexer

1. General description The 74HC157; 74HCT157 is a quad 2-input multiplexer. The device features select (S) and enable E inputs. A HIGH on S selects data source 1, a LOW data source 0. A HIGH on E forces all the outputs (1Y to 4Y) LOW. Inputs include clamp diodes. This enables the use of current

Quad 2-input multiplexer

Quad 2-input multiplexer