1. LENS CAP SUB-ASSEMBLY (WITH ASSEMBLED INDICATOR) AND GASKET SHIPPED UNASSEMBLED.

2. MATERIAL: POLYCARBONATE LENS WITH PAPER INDICATOR& IP RATED POLYURETHANE SEALING

GASKET WITH ADHESIVE.

3. ASSEMBLY INSTRUCTIONS FOR IP68 RATING

- CLEAN PANEL SURFACE AROUND MOUNTING HOLE WITH ALCOHOL

- PEEL LINER TAPE OFF ONE SIDE OF THE SEALING GASKET

- SLIDE SEALING GASKET ONTO INSTALLATION TOOL OR 0.264 PIN GAUGE AND INSERT THE TOOL/GAUGE IN

MOUNTING HOLE. USE THE TOOL/PIN GAUGE TO GUIDE SEALING GASKET TOWARDS MOUNTING HOLE AS

CENTERED AS POSSIBLE. PEEL REMAINING LINER TAPE SLOWLY AWAY

- INSERT LENS CAP INTO PANEL UNTIL LENS TABS ENGAGE WITH PANEL ON OPPOSITE SIDE

4. RECOMMENDED FOR USE WITH LEDS RATED AT 620 NM DOMINANT

WAVELENGTH.