汽车级智能高边开关 | PROFET™

High side power switch with integrated vertical power FET, providing embedded protection and diagnostic functions. • Current controlled input\n• Short circuit protection\n• Current limitation\n• Shutdown when undervoltage\n• Overvoltage protection (including load dump)\n• Switching inductive loads\n• Thermal shutdown with restart\n• ESD- Protection\n• Loss GND and loss Vbb protection\n• Very low stand by current;

Smart High-Side Power Switch

文件：383.87 Kbytes Page：20 Pages

Smart High-Side Power Switch One Channel: 1 x 1?

文件：435 Kbytes Page：18 Pages

Smart High-Side Power Switch

文件：383.87 Kbytes Page：20 Pages

封装/外壳：TO-261-4，TO-261AA 包装：卷带（TR）剪切带（CT）Digi-Reel® 得捷定制卷带 描述：IC PWR SWTCH N-CHAN 1:1 SOT223-4 集成电路（IC） 配电开关，负载驱动器

封装/外壳：TO-261-4，TO-261AA 包装：卷带（TR） 描述：IC PWR SWITCH N-CHAN 1:1 SOT223 集成电路（IC） 配电开关，负载驱动器

0.5W AF Power Amplifier

2-CHANNEL AF POWER AMP. FOR TAPE RECORDER, RADIO 0.5W TYP AF POWER AMP. FOR RADIO OR TAPE RECORDER 0.6 TO 0.9W AF POWER AMP.

Silicon planar type

Silicon planar type For stabilization of power supply ■ Features • High reliability, achieved by the DHD structure • Allowing to insert to a 5 mm pitch hole • Finely divided zener-voltage rank • Sharp rising performance • Wide voltage range: VZ = 2.0 V to 39 V

40 V low VCEsat NPN transistor

DESCRIPTION NPN low VCEsat transistor in a SOT54 plastic package. PNP complement: PBSS5140S. FEATURES • High power dissipation (830 mW) • Ultra low collector-emitter saturation voltage • 1 A continuous current • High current switching • Improved device reliability due to reduced heat gener

Low Power Two-Wire Ground Fault Interrupter Controller

Description The RV4140A is a low power controller for AC outlet appliance leakage circuit interrupters. These devices detect hazardous current paths to ground such as an appliance falling into water. The interrupter then open circuits the line before a harmful or lethal shock occurs. Features •

Photo Modules for PCM Remote Control Systems

DESCRIPTION These products are miniaturized receivers for infrared remote control systems. A PIN diode and a preamplifier are assembled on a lead frame, the epoxy package contains an IR filter. The demodulated output signal can be directly connected to a microprocessor for decoding. FEATURES •