Simple Solution for Dynamically Programming the Output Voltage of DC-DC Converters

INTRODUCTION  Figure 1 shows a typical dc-to-dc converter configuration. As in many PWM controllers, the non-inverting input of the voltage feedback error amplifier is internally connected to the reference voltage, Vr. The output voltage of the converter is set by a resistor divider network

REPLACING TRADITIONAL OPTO-DRIVERS

文件：1.64969 Mbytes Page：8 Pages

Simple Solution for Dynamically Programming the Output Voltage of DC-DC Converters

Dual Pre-Amplifier for Car Radio

Dual Pre-Amplifier for Car Stereo

DUAL RECORDING /PLAYBACK PRE AMPLIFIER CIRCUIT WITH ALC

Low Voltage Dual Pre-Amplifier Circuits

Low Voltage Dual Pre-Amplifier Circuits

Low Voltage Dual Pre-Amplifier Circuits

Low Voltage Dual Pre-Amplifier Circuits

DUAL RECORDING AND PLAYBACK PRE-AMPLIFIER IC FOR SINGLE/DOUBLE CASSETTE

Description The AN7316 is a monolithic integrated circuit for radio cassette recorder and built-in only fundamental function of Rec./playback pre-amp. with ALC functionin 2-channel 16-lead DIL plastic package.

Dual Recording and Playback Pre-Amplifier IC for SingleDouble Cassette

Features Built-in ALC low cut function Muting circuit built-in Wide operating voltage: VcC = 3.5V ~ 12V Description The AN7317 is a monolithic integrated circuit designed for radio cassette recorder and built-in record/playback pre- amplifier including ALC _and mute function.

SEMICONDUCTORS

文件：2.43533 Mbytes Page：31 Pages

SEMICONDUCTORS

文件：2.43533 Mbytes Page：31 Pages

Dual Pre-Amplifier for Car Stereo

Dual Recording /Playback Pre-Amplifier Circuit With ALC

Ultra quiet, ultra low-frequency accelerometer

Key features • Ultra low-noise electronics for clear signals at sub-μg levels • Ultra high sensitivity • Manufactured in ISO 9001 facility

16-/32-Channel, Serially Controlled 4,
1.8 V to 5.5 V, 2.5 V, Analog Multiplexers

GENERAL DESCRIPTION The ADG725/ADG731 are monolithic CMOS 32 channel/dual 16 channel analog multiplexers with a serially controlled 3-wire interface. The ADG732 switches one of thirty-two inputs (S1-S32) to a common output, D. The ADG725 can be configured as a dual mux switching one of sixteen

16-/32- Channel, Serially Controlled 4 ??1.8 V to 5.5 V, 짹2.5 V, Analog Multiplexers

GENERAL DESCRIPTION The ADG725/ADG731 are monolithic CMOS 32 channel/dual 16 channel analog multiplexers with a serially controlled 3-wire interface. The ADG732 switches one of thirty-two inputs (S1-S32) to a common output, D. The ADG725 can be configured as a dual mux switching one of sixteen

16-/32-Channel, Serially Controlled 4
1.8 V to 5.5 V, 2.5 V, Analog Multiplexers

文件：362.37 Kbytes Page：16 Pages

16-/32-Channel, Serially Controlled

文件：362.37 Kbytes Page：16 Pages