CMOS, Low Voltage Serially-Controlled, Octal SPST Switches

GENERAL DESCRIPTION The ADG714/ADG715 are CMOS, octal SPST (single-pole, single-throw) switches controlled via either a 2- or 3-wire serial interface. On resistance is closely matched between switches and very flat over the full signal range. Each switch conducts equally well in both directions a

CMOS、低压、SPI/QSPI/Microwire兼容型接口、串行控制、八通道单刀单掷开关

ADG714是一款互补性金属氧化物半导体(CMOS)、八通道单刀单掷(SPST)开关，通过一个三线式串行接口进行控制。开关之间的导通电阻匹配严格，并且在整个信号范围内，导通电阻曲线平坦。各开关在两个方向的导电性能相同，输入信号范围可扩展至电源电压范围。数据以8位形式写入这些器件，每一位对应一个通道。\n\n ADG714采用一个三线式串行接口，并且与串行外设接口(SPI)、QSPI™、MICROWIRE™接口标准和大多数数字信号处理(DSP)接口标准兼容。利用移位寄存器DOUT的输出，可以将若干这种器件以菊花链形式相连。\n\n 上电时，所有开关均处于断开状态，内部寄存器 • SPI/QSPI/MICROWIRE兼容型接口\n\n• 2.7 V至5.5 V单电源供电\n\n• ±2.5 V双电源\n\n• 导通电阻：2.5 Ω\n\n• 导通电阻平坦度：0.6 Ω;

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

文件：232.29 Kbytes Page：16 Pages

CMOS, Low Voltage Serially-Controlled, Octal SPST Switches

GENERAL DESCRIPTION The ADG714/ADG715 are CMOS, octal SPST (single-pole, single-throw) switches controlled via either a 2- or 3-wire serial interface. On resistance is closely matched between switches and very flat over the full signal range. Each switch conducts equally well in both directions a

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

文件：232.29 Kbytes Page：16 Pages

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

文件：188.79 Kbytes Page：16 Pages

Serially Controlled, Octal SPST Switches

文件：188.79 Kbytes Page：16 Pages

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

文件：232.29 Kbytes Page：16 Pages

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

文件：188.79 Kbytes Page：16 Pages

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

文件：188.79 Kbytes Page：16 Pages

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

文件：188.79 Kbytes Page：16 Pages

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

文件：188.79 Kbytes Page：16 Pages

CMOS, Low Voltage Serially Controlled, Octal SPST Switches

文件：188.79 Kbytes Page：16 Pages

Dual 5.3W Audio Power Amplifier Circuit

■Overview The AN7147N is an integrated circuit designed for power amplifier of 5.3W (12.0V, 3Ω) output. Stereo operation is enabled due to incorporating two amps. on one chip. It makes high reliability by smaller quiescent current compared with power amp. current and protectors built in. As qui

CATV amplifier module

DESCRIPTION Hybrid amplifier module in a SOT115J package operating with a voltage supply of 24 V (DC). FEATURES • Excellent linearity • Extremely low noise • Excellent return loss properties • Silicon nitride passivation • Rugged construction • Gold metallization ensures excellent reliabil

Silicon epitaxial planar type

Silicon epitaxial planar type For switching circuits For wave detection circuit ■ Features • Two MA3X704As are contained in one package (Two diodes in a different direction) • Optimum for low-voltage rectification because of its low forward rise voltage (VF) • Optimum for high-frequency rect

HIGH-SPEED DIFFERENTIAL COMPARATOR

文件：62.8 Kbytes Page：4 Pages

HIGH-SPEED DIFFERENTIAL COMPARATOR

文件：62.8 Kbytes Page：4 Pages