低功耗、双路输出LDO电压稳压器

XC6411系列是高精度,低噪声,采用CMOS工艺生产的双路正电压输出LDO电压稳压器。该系列具有极低的静态电流， 每个通道0.8μA /ch. (TYP.)，内部包含了一个参考电压源,误差放大器,电流Foldback电路,相位补偿电路和三极管驱动电路。\n\n 这些不同的封装形式适合于各种高密度电路板的应用需要。例如在手机中的应用。\n\n 每一个电压稳压器的输出电压都由激光微调单独设定，每一路输出电压都可在0.9V到5.0V的范围内以0.1V的间隔选择。\n\n XC6411使用低ESR的陶瓷电容，便可使输出稳定。该系列的两路输出通道VR1和VR2是完全隔离的，相互之间没有相互的干扰 ·最大输出电流：200mA(300mALimitTYP.),(VOUT=3.0V、VIN=4.0V时)\n·输入输出电压差：320mV@IOUT=100mA(VOUT=3.0V时)\n·工作电压范围：1.5V～6.0V\n·输出电压：0.9～5.0V\n·高精度：±2%(1.5\n·低消耗电流：0.8μA/ch(TYP.)\n·工作温度范围：-40℃～85℃\n·低ESR电容：陶瓷电容;

0.8uA Low Power Consumption Dual Voltage Regulator

文件：697.35 Kbytes Page：28 Pages

0.8uA Low Power Consumption Dual Voltage Regulator

文件：697.35 Kbytes Page：28 Pages

0.8uA Low Power Consumption Dual Voltage Regulator

文件：697.35 Kbytes Page：28 Pages

0.8uA Low Power Consumption Dual Voltage Regulator

文件：697.35 Kbytes Page：28 Pages

0.8uA Low Power Consumption Dual Voltage Regulator

文件：697.35 Kbytes Page：28 Pages

Bilateral Trigger Diodes (DIACS)

Description: The NTE6407 thru NTE6412 are bilateral trigger DIACs offering a range of voltage characteristics from 28V to 63V. These devices are triggered from a blocking–to–conduction state for either polarity of applied voltage whenever the amplitude of applied voltage exceeds the breakover v

AUDIO/VIDEO SWITCH MATRIX

DESCRIPTION The STV6411A is a highly integrated I2C bus-controlled audio and video switch matrix, optimized for use in digital set-top box applications. It provides all the audio and video routings required in a full three scart set-top box design. It is also fully pin compatible with STV6410A,

AUDIO/VIDEO SWITCH MATRIX

DESCRIPTION The STV6411A is a highly integrated I2C bus-controlled audio and video switch matrix, optimized for use in digital set-top box applications. It provides all the audio and video routings required in a full three scart set-top box design. It is also fully pin compatible with STV6410A,

AUDIO/VIDEO SWITCH MATRIX

DESCRIPTION The STV6411A is a highly integrated I2C bus-controlled audio and video switch matrix, optimized for use in digital set-top box applications. It provides all the audio and video routings required in a full three scart set-top box design. It is also fully pin compatible with STV6410A,

DUAL-MODE DIGITAL CAMERA CO-PROCESSOR

DESCRIPTION STMicroelectronics Imaging Division has produced the camera co-processor STV0681 which, used with CIF/VGA sensors as part of a low cost dual-mode camera chipset, allows a new line of low cost cameras or toy products to be brought to the market. STV0681 is a mask ROM version of STV0680