The isolating transducers IM12-AI01-1I-1IUHPR/24VDC/CC transmit analog measured

signals galvanically isolated. The devices are

suitable for operation in zone 2.

The 1-channel device has one input for the

operation of HART® 2-wire transducers as

well as active and passive HART® 2-wire

transmitters. Connection is via removable

spring type terminals. The device can be powered from a power bridge that also transmits a

collective fault signal.

The device is equipped with a 4…20 mA input circuit and 4…20 mA output circuit (either

as source or sink) or 1…5 V (source). The input signals are transmitted 1:1 without interference within a range of 3.8…20.5 mA. In addition, digital signals can also be transmitted

bidirectionally in accordance with the HART®

protocol. Wire break ( 22 mA) in the transducer circuit are

output as current < 3.5 mA/voltage < 0.875 V.

The devices have a green power LED (Pwr).

For each input circuit there is a red status

LED. An error in the input circuit causes the

red LED to flash according to NE44.

The device can be used in safety circuits up to

SIL2 (high and low demand according to IEC

61508) and meets the requirements of NE21.

The device is equipped with removable

spring-type terminals.

■ Input circuits monitored for wire break and

short circuit

■ Complete galvanic isolation

■ HART transparent

■ Removable spring type terminals

■ Male connector for power bridge incl. in

delivery

■ ATEX use in Zone 2, cUL

■ SIL 2