The 1-channel IM1-12EX-MT isolating switching amplifier is equipped with an intrinsically

safe input circuit.

Sensors according to EN 60947-5-6 (NAMUR)

or potential-free contact transmitters can be

connected to the device.

The output circuits feature 2 potential-free

MOSFET transistors controlled in parallel for

switching voltages of up to 250 VAC at a maximum frequency of 1 kHz.

You can toggle between working or closed

current, resp. NO or NC mode via three

switches at the front. The switching state of

channel 1 is thereby transmitted to the outputs

1 and 2.

When using mechanical contacts, wire-break

and short-circuit monitoring must be switched

off or the contacts must be wired to resistors

(II) (see circuit diagram).

The Pwr LED lights green to indicate operational readiness. The 2-color LED 1 lights yellow to indicate the switching status of the output. In the event of an input circuit error, the 2-

color LED turns red, with the input circuit monitoring switched on. Thereupon the MOSFET

outputs are blocked.

■ 2 transistor outputs (MOSFET)

■ Output mode adjustable (NO/NC mode)

■ Input circuits monitored for wire-break and

short-circuit

■ Complete galvanic isolation

■ Input reverse-polarity protected

■ ATEX, IECEx, cUL, cFM, CSA, TR CU,

NEPSI, KOSHA, CCOE, INMETRO

■ Installation in zone 2