Features

■Rectangular, plastic, Ultem

■Status displayed via LED

■Angle detection via one axis with 360 °

measuring range

■High protection class IP68/IP69K

■Protected against salt spray and rapid

temperature change

■15…30 VDC

■M12 × 1 male connector, 5-pin

■Two counter-running 4…20 mA analog

outputs improve machine safety through

redundancy

■The start, end and center point of the

measuring range can be adjusted using teach

adaptor TX1-Q20L60

■Individual parameterization possible with

USB-2-IOL-0002

Functional principle

The inclinometers use an acceleration

measuring cell to determine the angle. The

Earth's gravity is used as a reference. If the

inclinometer changes its angle relative to

the Earth's gravity, this is detected by the

acceleration measuring cell.

The robust sensors are positioned with the

cast side on a flat surface so that the casting

compound is covered. The sensor is then

secured with two screws.