Features

● CSI-2 TX/RX Interface

 MIPI CSI-2 compliant (Version 1.01 Revision

0.04 – 2 April 2009)

 Configurable to TX or RX controller

 Supports up to 1Gbps per data lane

 Supports up to 4 data lanes

 Supports video data formats

- RX: RAW8/10/12/14, YUV422 (CCIR/ITU 8/10-

bit), RGB888/666/565 and User-Defined 8-bit

- TX: YUV422 (CCIR/ITU 8/10-bit), YUV444,

RGB888/666/565 and RAW8/10/12/14

● Parallel Port Interface

 Supports data formats

- 24-bit bus – un-packed format (Both Input and

Output mode)

 RGB888/666/565, RAW8/10/12/14 and

YUV422 8-bit (on 8/16-bit data bus) and 10-bit

data formats.

 YUV444 (Parallel Input mode only)

- YUV422 8-bit – ITU BT.656 and ITU BT.601

(Parallel input mode only)

 Up to 100 MHz PCLK frequency for Output

mode, and 166 MHz for Input mode.

● I2C Slave Interface (CS = L)

 Support for normal (100 kHz), fast mode (400

kHz) and special mode (1 MHz)

 Configure all TC358746AXBG/TC358748XBG

internal registers

● SPI Slave Interface (Only applicable in CSIOut

configuration, MSEL = H, and CS = H)

 SPI interface support for up to 25 MHz

operation.

 Configure all TC358746AXBG/TC358748XBG

internal registers

● GPIO signals

 3 GPIO signals

- Three GPIO signals can be configured as

control signals (MCLK, CXRST, XShutdown) for

CSI-2 RX device.

- Or one GPIO signal can be configured as INT

signal for Parallel interface.

● System

 Clock and power management support to

achieve low power states.

● Power supply inputs

 Core and MIPI D-PHY: 1.2 V

 I/O: 1.8 V – 3.3 V