Operating Voltage Range of 4.5 V to 5.5 V

Low Power Consumption, 80-μA Max ICC

Typical tpd = 11 ns

±6-mA Output Drive at 5 V

Low Input Current of 1 μA Max

Inputs Are TTL-Voltage Compatible

Lock Bus-Latch Capability

True Logic

High-Current 3-State Outputs Can Drive Up

To 15 LSTTL Loads

description/ordering information

These octal bus transceivers are designed for asynchronous two-way communication between data buses. The

control-function implementation allows for maximum flexibility in timing.

The ’HCT623 devices allow data transmission from the A bus to the B bus or from the B bus to the A bus,

depending upon the logic levels at the output-enable (OEAB and OEBA) inputs.

The output-enable inputs disable the device so that the buses are effectively isolated. The dual-enable

configuration gives the transceivers the capability to store data by simultaneously enabling OEAB and OEBA.

Each output reinforces its input in this transceiver configuration. When both OEAB and OEBA are enabled and

all other data sources to the two sets of bus lines are in the high-impedance state, both sets of bus lines (16 total)

remain at their last states. The 8-bit codes appearing on the two sets of buses are identical.

To ensure the high-impedance state during power up or power down, OEBA should be tied to VCC through a

pullup resistor and OEAB should be tied to GND through a pulldown resistor; the minimum value of the resistor

is determined by the current-sinking/current-sourcing capability of the driver.