Features

• STEVAL-IOM001V1

– IO-Link master PHY based on L6360

– Interrupt diagnostics pin

– I²C and UART interface

– SPI (slave) interface

– 65 mA selectable (3.3 or 5.0 V) linear regulator

– CQ (push-pull) and L+ (high side) switches

– IQ additional IEC61131-2 type 1 digital input

– L+ and CQ overload and overheating protections with non-dissipative cutoff

function

– QFN-26L (3.5x5x1 mm) package

– Operating voltage range from 18 to 32.5 V

– Additional high side switch for L+ heavy loads (IPS161H)

– LEDs for status and diagnostics

– Ground and VCC wire break protections

– EMC compliance with IEC61000-4-2, IEC61000-4-3, IEC61000-4-5

– Equipped with ST morpho connectors

– CE certified

– RoHS and China RoHS compliant

• NUCLEO-F446RE

– STM32F446RET6 32-bit Micro-controller based on ARM®Cortex®-M4 core

(180 MHz max.) with 512-Kbyte Flash memory and 128 (+4) Kbyte RAM

– Two types of extension resources: Arduino™ UNO Revision 3 connectivity

and ST morpho extension pin headers for full access to all STM32 I/Os

– Mbed-enabled (http://mbed.org)

– On-board ST-LINK/V2-1 debugger/programmer with SWD connector:

selection-mode switch to use the kit as a standalone ST-LINK/V2-1

– Two push-buttons: USER and RESET

Description

The P-NUCLEO-IOM01M1 is an STM32 Nucleo pack composed of the STEVALIOM001V1

and the NUCLEO-F446RE boards. The STEVAL-IOM001V1 is a single

IO-Link master PHY layer (L6360) while the NUCLEO- F446RE runs an IO-Link stack

rev 1.1 (developed by and property of TEConcept GmbH, license limited to 10k

minutes, renewable without additional costs).

The STM32 Nucleo pack provides an affordable and easy-to-use solution for the

evaluation of IO-Link applications, L6360 communication features and robustness,

together with the STM32F446RET6 computation performance. The pack, hosting up

to four STEVAL-IOM001V1 to build a quad port IO-Link master, can access the IOLink

physical layer and communicate with IO-Link Devices.

You can evaluate the tool via the dedicated GUI (IO-Link Control Tool©, property of

TEConcept GmbH) or use it as an IO-Link master bridge accessible from the

dedicated SPI interface: source code of demo project (Low-Level IO-Link Master

Access Demo Application, developed by TEConcept GmbH) and API specification are

available for free.