Features

• 1‑Quadrant source measurement unit with high resolution, and measurement

flexibility:

– Programmable voltage source from 1.6 to 3.6 V

– Output current rating 500 mA with over-current protection (OCP) at

550 mA

– Programmable sampling rate from 1 SPS to 100 kSPS

– Dynamic measurement:

◦ 100 nA to 550 mA current / 160 nW to 1.65 W power

measurements

◦ 50 kHz bandwidth / 1.6 MHz acquisition / 2 accuracy

◦ Compatible with EEMBC® ULPMark™ tests

• Auxiliary output voltage source from 1.6 to 3.6 V under up to 2 A (no current

measurement, OCP at 2.5 A)

• Debugging of embedded applications:

– JTAG / Serial Wire Debug (SWD):

◦ SWD (Serial Wire Debug) and SWV (Serial Wire Viewer)

communication support up to 10 MHz

◦ JTAG communication support up to 20 MHz

– UART interface on Virtual COM port (VCP) with frequency up to 12 MHz

– Multi-path bridge USB to SPI/I2C/CAN/GPIOs

– Integrated level shifter I/O voltage 1.6 to 3.6V adaptable

• Four bi-color LEDs providing probe state

• Three STDC14 to MIPI10 / STDC14 / MIPI20 flat cables with 1.27 mm pitch

connectors

• Four cables (two male/male and two male/female)

• USB Type-C® connector:

– Powered through USB Type-C® (5 V/3 A maximum)

– USB 2.0 high‑speed interface

– Probe firmware update through USB

• Direct support from STM32CubeMonitor-Power software tool